Digilyzer DL1 User Manual

More documents

Recommendations

Info

Battery replacement Insert three pieces of 1.5 V alkaline batteries, type AA, LR6, AM3 into the Digilyzer battery compartment, as shown below. 1. Press 1. Press 2. Pull Overview Rubber cushion Speaker Fig 2-10, Open battery compartment Fig 2-11, Inserted batteries NOTE • The use of rechargeable NiCd- or NiMH-batteries causes shorter battery lifetime than specified. • Do not insert batteries of different types. • Note the correct polarities of the inserted batteries. • Remove the batteries as soon as they are flat. 14
3. FIrsT sTeps This chapter is a quick guide explaining how to make the first measurements with the Digilyzer. The example assumes an S/PDIF signal as input (e.g. a CD player with S/PDIF output playing a music CD). 1. Insert batteries 2. Connect the S/PDIF signal to the RCA input. 3. Reset the Digilyzer to default state by holding down the ESC key and simultaneously pressing the ON button for about two seconds. 4. Select S/PDIF as input format - Move the cursor (inverted box) one step right to the format menu by using the cursor keys. - Press the enter key to open the format menu. - Select S/PD and press the enter key. -> The channel status information is displayed and music is audible trough the built-in speaker. First Steps 15 3 2 Fig 3-01, Digilyzer Fig 3-02, Format selection 4
Page 1 and 2: Digilyzer DL1 User Manual
Page 3 and 4: INdex: 1. In t r o d u c t Io n 4 C
Page 5 and 6: egistration Introduction Register a
Page 7 and 8: Warnings In order to avoid any prob
Page 9 and 10: Functions Overview The Digilyzer fe
Page 11 and 12: • Some functions, e.g. SCOPE, are
Page 13: Connectors The Digilyzer includes t
Page 17 and 18: 8. Change auto power off time - Mov
Page 19 and 20: Menu Bar The menu bar allows the us
Page 21 and 22: setup screen Basic Operation The se
Page 23 and 24: display Basics Debugging and analyz
Page 25 and 26: Following errors are analyzed/visua
Page 27 and 28: 5. MeAsureMeNT FuNCTIoNs Channel St
Page 29 and 30: Row number Measurement Functions Pa
Page 31 and 32: Consistency Check The consistency c
Page 33 and 34: Bit statistic The bit statistic fun
Page 35 and 36: Logger The event logger records any
Page 37 and 38: Displaying events The display of th
Page 39 and 40: vu+ppM The Digilyzer offers a combi
Page 41 and 42: Level Measurement The Level menu fe
Page 43 and 44: Level RMS The analog Level RMS func
Page 45 and 46: Level Sweep The Digilyzer supports
Page 47 and 48: THd+N The THD+N function (Total Har
Page 49 and 50: scope The scope shows the waveform
Page 51 and 52: 7. ACCessorIes MiniLINK MiniLINK al
Page 53 and 54: 8. AppeNdIx 1C2f Format The AES3 st
Page 55 and 56: Logger Event Coding The following c
Page 57 and 58: DL1 event Cs WordLeN Cs CHACHB Cs o
Page 59 and 60: Byte Bit Bit-info Digilyzer Explana
Page 61 and 62: Appendix Consumer Format Coding Ove
Page 63 and 64: Appendix Byte Bit Bit-info Digilyze
Page 65 and 66:
Dimensions (L x W x H) 163 x 86 x 4
show all

Digilyzer DL1 User Manual

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?