Cartridge and block spindles - Gilman USA

Gilman4000CCartridge spindles.88.5017.754.50 10.50 2.752.753.88.311.531.003/8 Soc. HD. C.S. (4)Ø4.88 B.C..625Ø.750Ø4.000Ø4.25Ø3.500 Ø5.754000C cartridge spindles and4000B block spindles are availablewith three standard nosetypes and six standard internalconstruction types.Nose types:• #40 N.M.T.B. taper• Boring nose• HSKC63 manual clampInternal constructions:• X1 duplex ball bearing atnose end with contact seal• X2 duplex ball bearing atnose end with labyrinth seal• X2C duplex ceramic ballbearing at nose end withcontact seal• X3 triplex ball bearing atnose end with contact seal• X4 triplex ball bearing atnose end with labyrinth seal• X4C triplex ceramic ball bearingat nose end with labyrinthsealRefer to the 4000C/4000Bspecification chart, as well asthe sizing instructions on page5, to select the proper spindlefor your rotational requirements.Special designs are alsoavailable to meet your specificneeds.Ø4.00Ø1.6253/8 Sq. key4.50.88 2.75Ø1.6253/8 Sq. keyØ4.004.50.88 2.75Ø1.6253/8 Sq. keyØ.66Ø.5317.8610.50Ø1.0040 - #40 N.M.T.B. Taper shaftBN - Boring nose18.6910.50Ø.531.00*2.861.53*1.00.991/2-13 Tap (4)Ø2.625 B.C.Ø3.94Ø2.207 Ø5.75Ø4.253.691.533/8 Soc. HD. C.S. (4)Ø4.88 B.C.M8X1.25 Tap (6)Ø3.110 B.C.Ø5.75Ø4.25HM - HSKC63 Manual clamp(T-wrench not included)*4000C & 4000B Specification chartBearing Maximum Maximum Radial stiffness Nose end Drive endand seal thrust R.P.M. at noseconstruction (lbs.) (lbs./in.) Bearing Seal Bearing Sealnumber4000C Approx. wt. 38 lbs.For cartridge spindlebrackets, see “Gilman spindleaccessories”, page 47.X1L 161 3,150 460,000 55 mm I.D. 45 mm I.D.X1M 394 3,150 510,000 duplex Contact duplex LabyrinthX1H 855 3,150 540,000 ball ballX2L 161 10,800 460,000 55 mm I.D. 45 mm I.D.X2M 394 9,200 510,000 duplex Labyrinth duplex LabyrinthX2H 855 6,100 540,000 ball ballX2CL 105 14,400 460,000 55 mm I.D. 45 mm I.D.X2CM 220 12,600 510,000 duplex Labyrinth duplex LabyrinthceramicceramicballballContinued on next page22 ©2011 Gilman USA, LLC