Cartridge and block spindles - Gilman USA

5.001.12 3.00.6224.3817.38.502.005.50Ø1.06 Ø1.56.665/8-11 Tap (4)Ø4.000 B.C.1.000Gilman6500BBlock spindlesØ1.250Ø2.250Ø6.56Ø5.0627.881/2 Sq. key1.004.500(4) Tapped holes.See page 47for location.500 .391.00015.50016.258.1259.2502.503.00050 - #50 N.M.T.B. Taper shaft*1/2 Soc. HD. C.S. (6)3.125 3.1253.7507.50.25Locating edge5.001.13 3.0025.1817.37Ø.53.652.811.70M10X1.5 Tap (6)Ø4.685 B.C.Ø2.2501/2 Sq. keyØ3.467 Ø5.51Ø6.561.00 4.500 7.88BN - Boring nose*.255.001.13 3.00Ø.5326.2817.373.91.65Ø2.250Ø6.56Ø5.911/2 Sq. keyHM - HSKC100 Manual clamp(T-wrench not included)*6500B Approx. wt. 225 lbs.6500C & 6500B Specification chart (continued)Bearing Maximum Maximum Radial stiffness Nose end Drive endand seal thrust R.P.M. at noseconstruction (lbs.) (lbs./in.) Bearing Seal Bearing SealnumberX3L 570 2,125 1,450,000 85 mm I.D. 70 mm I.D.X3M 1695 2,125 1,620,000 triplex Contact duplex LabyrinthX3H 3790 2,125 1,700,000 ball ballX4L 570 5,700 1,450,000 85 mm I.D. 70 mm I.D.X4M 1695 3,800 1,620,000 triplex Labyrinth duplex LabyrinthX4H 3790 3,000 1,700,000 ball ball* Maximum tool overhang(from *) = 8 (in.)Maximum torque = 4100 (in.- lbs.)WK 2 = 104.2 (lb.- in. 2 )Note: Spindles are supplied with medium bearingpreloads as standard. Light and heavy bearingpreloads are available.Tool overhang pertains to boring, end milling andnonsupported arbor milling.X4CL 343 9,100 1,450,000 85 mm I.D. 70 mm I.D.X4CM 714 7,150 1,620,000 triplex Labyrinth duplex Labyrinthceramicceramicballball©2011 Gilman USA, LLC35