globe

71R5.2 Dip-SwitchesDescription OFF ONDIP1 Control 1-5 function. Step by step. Opening.DIP2 Selection of direction. Opening towards gearmotor. Closing towards gearmotor.DIP3 Disengagement on the closingstop with JR2=ONDisengagement on the closingstop with JR2=OFFDIP4 State of door at start.Open.Indicates how the electronic panelconsiders the door at the time ofstart.2 mm 0,5 mmNote: use this selection to prevent an incompleteclosing of the sectional doors.5 mmWith DIP1=OFF the first control 1-5 closesthe door.With DIP1=ON the first control 1-5 opensthe door.Close.The first control 1-5 opens the door.Note: automatic closing cannot be the firstcontrol even if enabled.DIP5 Electric lock release. Disabled. Enabled.Before opening from closed door, a thrustis included in closing to facilitate electriclock release.DIP6 Pre-flashing light.Disabled during opening.Enabled only with automatic closure withTC>3 s.Enabled for both opening and closing.GB5.3 JumpersDescription OFF ONSO Safety operation. The opening of contact 1-8 with door The opening of contact 1-8 with doorstopped enables opening manoeuvre. In stopped prevents any operation.the last 30 mm before closing stop, thiscauses stop.JR2 Automation type. Up and over door with counterweight. Sectional and up and over door with springs.JR3 Maximum limit manoeuvering Normal closing force.Reduced closing force.forces.Note: use safety edge.JR4 Built-in radio receiver. Disabled. Enabled.5.4 SignalsLED ON FlashingPOWER ALARM 24 V= power supply. Encoder / automation fault.SAIndicates that at least one of the N.C. safety contactsUpon starting the LED flashes indicating the countis open.of the operations which have been carried out:each quick flashing = 1000 operationseach slow flashing = 10000 operationsSIG During radio transmitter enabling/storing phase. During radio transmission reception.21 GLOBE - IP1839