PNEG-1162CEX - DMC DIII Stir-Ator - David Manufacturing Co.
PNEG-1162CEX - DMC DIII Stir-Ator - David Manufacturing Co.
PNEG-1162CEX - DMC DIII Stir-Ator - David Manufacturing Co.
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
5. Installation4. NOTE: Augers used in 11 m or wider grain bins require the trolley hold-down rods to be moved tothe bottom hole position. This is done by removing the cotter pin and pulling the rod out andreinserting it in the bottom holes. Refer to Figure 5J and Figure 5K.Hold-downrod holesFigure 5J Auger TrolleyHold-down rodFigure 5K Trolley Hold-Down Rod5. Place the auger trolley onto the frame, as shown in Figure 5L on Page 14. Check the orientationof the trolley in relation to the track drive unit and bin wall.6. Fit the auger trolley drive post and arm, using the lower hole in the post and two (2) cotter pins(one below, one above the trolley) provided.<strong>PNEG</strong>-<strong>1162CEX</strong> <strong>DMC</strong> <strong>DIII</strong> <strong>Stir</strong>-<strong>Ator</strong> 13
Change language