PNEG-1162CEX - DMC DIII Stir-Ator - David Manufacturing Co.

5. InstallationFigure 5AV Lock Unit with Vise Grips15. Now position the centre of the stirrer so that it is higher than the track drive unit. Refer to the tablebelow for the correct height difference for the bin diameter.Bin DiameterUp to 18' (5.5 m)Up to 27' (8.2 m)Up to 36' (11.0 m)Over 36' (11.0 m)Height Difference between Centre and Side25 mm40 mm55 mm70 mmConnection to Power SupplyWARNINGIt is essential that the Stir-Ator is supplied via a safety isolator located at theeaves hatch of the bin. This must be rated to IP 65 minimum and have a currentrating no less than 32 amps. The switch must also be lockable.DANGERWARNINGOnce the auger is installed into a grain bin, the bin becomes a hazardousenvironment. No-one must ever be in the bin when the auger is operating.GSI recommends the installation of safety switches on the personnel door sothat whenever the door is opened all equipment stops automatically and cannotbe restarted without the door first being closed and the operator restarting atthe main control panel.WARNINGDANGERGSI recommends the installation of suitable emergency stops to stop allequipment within the bin in the event of an emergency.This is the responsibility of the installer and a requirement under the CEdirectives to which this installation must comply. Failure to do so can endangerlife and will invalidate any warranties and guarantees.PNEG-1162CEX DMC DIII Stir-Ator 29