PNEG-1162CEX - DMC DIII Stir-Ator - David Manufacturing Co.

More documents

Recommendations

Info

5. InstallationAuger trolleydrive armAuger trolleydrive postTowards bin wallFigure 5L Mount Trolley on Frame RailsFigure 5M Fit Auger Trolley Drive Post and Arm (Use lower holes.)7. Now bolt the inboard (bin centre) frame end onto the rails, using the carriage bolts provided.(See Figure 5N.)Figure 5N Fit Inboard (Bin Centre) Frame End8. Check that the hold-down rods are positioned correctly. There should be approximately 10 mmbetween the rod and the bottom of the rail. (See Figure 5O on Page 15.)14 PNEG-1162CEX DMC DIII Stir-Ator
5. Installation10 mmFigure 5O Correct Hold-Down Rod Position9. The yoke assembly is attached to the frame rails by placing the pivot tube into the center framesupport. Secure by placing a cotter pin through the tube. (See Figure 5P and Figure 5Q.)Figure 5P Centre Yoke AssemblyFrame inboard endCentre yoke pivot tubeFigure 5Q Centre Yoke PivotCotter pinPNEG-1162CEX DMC DIII Stir-Ator 15
Page 1 and 2: DMC DIII Stir-AtorOwner’s ManualP
Page 3 and 4: Table of ContentsContentsChapter 1
Page 5 and 6: Installation1. The correct installa
Page 7 and 8: 3. Bin LoadingUser’s must be awar
Page 9 and 10: 5. InstallationGSI RECOMMENDS THAT
Page 11 and 12: 5. InstallationFigure 5E Suspension
Page 13: 5. Installation4. NOTE: Augers used
Page 17 and 18: 5. Installation12. NOTE: 36' and la
Page 19 and 20: 5. Installation15. Attach the slip
Page 21 and 22: 5. InstallationCable glandsBeam box
Page 23 and 24: 5. Installation5 Core H07 cableFigu
Page 25 and 26: 5. InstallationNOTE: Installer must
Page 27 and 28: 5. InstallationCentre Suspension As
Page 29 and 30: 5. InstallationFigure 5AV Lock Unit
Page 31 and 32: 5. Installation6. Use a small grind
Page 33 and 34: 5. Installation9. Re-check and adju
Page 35 and 36: 7. WarrantyGSI Group, LLC Limited W

PNEG-1162CEX - DMC DIII Stir-Ator - David Manufacturing Co.

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?