PNEG-1162CEX - DMC DIII Stir-Ator - David Manufacturing Co.

More documents

Recommendations

Info

5. Installation6. Run a cable from the beam box to the track motor, as shown in Figure 5AI on Page 23 andFigure 5AJ, attaching to the cable arms and end yoke with wire ties.3 CoreH07 cableFigure 5AJ Track Motor CableElectrical ConnectionsFigure 5AK Track Motor CableMake connections in accordance with connection diagrams in Figure 5AL and Figure 5AM on Page 25.NOTE on 1 phase units, two (2) parallel LIVE and two (2) parallel NEUTRAL supplies must be used.24 PNEG-1162CEX DMC DIII Stir-Ator
5. InstallationNOTE: Installer must ensure continuity oflow impedance protective earth circuit to allconductive surfaces and electrical equipment.Figure 5AL Slip Ring Connections - 3 Phase UnitsFigure 5AM Beam Box Wiring - 3 Phase Triple Auger UnitsBEFORE PUTTING INTO SERVICE, THE INSTALLER MUST CHECK THAT ALL CABLE GLANDS ANDSTRAIN RELIEFS ARE FULLY TIGHTENED.PNEG-1162CEX DMC DIII Stir-Ator 25
Page 1 and 2: DMC DIII Stir-AtorOwner’s ManualP
Page 3 and 4: Table of ContentsContentsChapter 1
Page 5 and 6: Installation1. The correct installa
Page 7 and 8: 3. Bin LoadingUser’s must be awar
Page 9 and 10: 5. InstallationGSI RECOMMENDS THAT
Page 11 and 12: 5. InstallationFigure 5E Suspension
Page 13 and 14: 5. Installation4. NOTE: Augers used
Page 15 and 16: 5. Installation10 mmFigure 5O Corre
Page 17 and 18: 5. Installation12. NOTE: 36' and la
Page 19 and 20: 5. Installation15. Attach the slip
Page 21 and 22: 5. InstallationCable glandsBeam box
Page 23: 5. Installation5 Core H07 cableFigu
Page 27 and 28: 5. InstallationCentre Suspension As
Page 29 and 30: 5. InstallationFigure 5AV Lock Unit
Page 31 and 32: 5. Installation6. Use a small grind
Page 33 and 34: 5. Installation9. Re-check and adju
Page 35 and 36: 7. WarrantyGSI Group, LLC Limited W

PNEG-1162CEX - DMC DIII Stir-Ator - David Manufacturing Co.

Create successful ePaper yourself

Delete template?

Save as template?