PNEG-1162CEX - DMC DIII Stir-Ator - David Manufacturing Co.

5. Installation12. NOTE: 36' and larger units have an additional center support yoke. Attach the top end of the supportyoke to the center extension tube using a 1-3/4" spacer tube, one 3/8" x 2-1/2" hex head bolt and hexlock nut. Locate approximately 4" from wire support swing arm toward outboard end side. Placebottom of support yoke onto the frame rail angle flange and fasten with 3/8" x 1" set screw.(See Figure 5U and Figure 5V.)Figure 5U Fit Intermediate Yoke and Cable Swing ArmFigure 5V Attach Yoke to Steel Angle13. Attach the slip ring unit to the centre yoke assembly using a 1/2" x 3" bolt, lock nut and roll pin asshown in Figure 5X on Page 18.Figure 5W Slip Ring UnitPNEG-1162CEX DMC DIII Stir-Ator 17