MA/FS-1535 SERIES - toshiba tec europe

5. TROUBLESHOOTING EO18-11004A5. TROUBLESHOOTING5. TROUBLESHOOTINGProblems Cause SolutionPower is not turned ON. • The fuse in the PS unit hasblown.• Input voltage to the ECR is notwithin the rated voltage.• Replace the fuse.Nothing is displayed.No key entry is accepted.Specific key entry is notaccepted.Printer does not print.Paper jam• Output voltage from thetransformer is not within the ratedvoltage.• Failure of the MAIN PC Board.• Failure of the FIU PC Board.• Failure of the MAIN PC Board.• Failure of the Keyboard Unit.• Failure of the MAIN PC Board.• Failure of the Keyboard Unit.• FPC failure.• Failure of the Printer Unit.• Failure of the MAIN PC Board.• Paper outlet is jammed.• Foreign object entered into theprinter.• Paper being used does not meetthe standard.• If it is not a power failure, checkfor the power supply to the ACoutlet with another electricappliance. When the power isnot supplied, contact yournearest power company.• Replace the PS Unit.• Replace the MAIN PC Board.• Replace the FIU PC Board.• Replace the MAIN PC Board.• Replace the Keyboard Unit.• Replace the MAIN PC Board.• Replace the Keyboard Unit.• Replace the Keyboard Unit.• Replace the Printer Unit.• Replace the MAIN PC Board.Remove the jammed paper usingthe following procedure.1. Cut the paper at the paper inlet.2. Raise the Paper Free Lever toseprate the print head from theplaten.3. Carefully pull out the remian ofpaper straight from the paperoutlet.• Use the paper whichcorresponds to the specificationdescribed in Section 7.3 PaperSpecifications.5- 1