MCset 3 part1 user_manual - Schneider Electric

More documents

Recommendations

Info

Steps for the testsRemove front protective cover plates.See chapter “Instructions for access tothe inside of a cubicle”.Connect the voltage injection circuit to cablelugs.Open the earthing switch. See chapter“Opening the earthing switch”, then carryout the tests.At the end of the tests:- Close the earthing switch- Remove the accessories.07897302EN indice : C019
Operating InstructionsExtracting or inserting themobile partStarting statusCubicle + mobile partin a disconnected /testposition.Note: the following operations are describedusing the extraction and insertion toolapplication and the removal of mobile ERTparts ......the operating mode is identical when usingthe extraction table.These tools can be adjusted in width andheight. See the corresponding <strong>manual</strong>s.ExtractionOpen the access door to the mobile part bypulling then turning the handle towards theright.Disconnect the LV auxiliary cord by pressingon the red button and by pulling the socketlock (circuit-breaker or contactor).Bring the ERT into position (the pinsentered into the holes intended for thispurpose on the cubicle).Lock the latching mechanism by pushing in,then tipping the 2 OED notching operatingmechanism handles to the right (checklatching mechanism).Block the 2 ERT castors.20 07897302EN indice : C0
Page 1 and 2: GeneralGlossaryNote: this document
Page 3 and 4: General descriptionWarning for read
Page 5 and 6: General descriptionRHB, RHC cubicle
Page 7 and 8: General descriptionROLLARC 400CTV1E
Page 9: General descriptionProcedure pictog
Page 13 and 14: Instructions for accessto the insid
Page 15 and 16: Instructions for accessto the insid
Page 17: Steps for the testsVoltage presence

MCset 3 part1 user_manual - Schneider Electric

Create successful ePaper yourself

Delete template?

Save as template?