IWS_Training_Guide_v.. - FF-Automation

IWS Training GuideThe Licensing Process for IWS SoftwareInstalling or Upgrading a Soft Key License Locally Be sure InduSoft Web Studio plus Service Pack 3 is installed on your development PC. You need to install the InduSoft Remote Agent program CEServer.exe into your Windows CE device’s nonvolatilefolder. The non-volatile folder can be different with every Windows CE-device. Check with your vendorfor specific information.Where to find CEServer.exe:The CEServer.exe file is located on your Development PC in a subfolder contained in a folder where youinstalled the Program files. The file is located in the \Redist folder, where is a sub-folder namethat specifies your processor type.E.g. C:\Program Files\InduSoft Web Studio v6.1\Redist\There may be different subfolders based on what options you selected during the IWS installation process.The \WinCE 4.0 subfolder is for platforms using Windows CE 4.0 and later, while the \CEView subfolder isused for platforms using Windows CE 3.0Notes:• The non-volatile folder retains data after a power-up or reboot of the Windows CE device.• The non-volatile folder can be different with every Windows CE-device. Check with your vendor forspecific information on which folder is the non-volatile folder.• Depending on the Windows CE device, the non-volatile folder can be located on the on-board flashmemory or on a removable memory (e.g. Compact Flash) storage card. If the InduSoft license isstored on a removable memory storage card, the Windows CE-based device will not be licensed if theremovable memory storage card is not properly installed in (or removed from) the device.How to install the CEServer.exe file:• You can copy the CEServer.exe file using ActiveSync (requires USB port or Serial Connection).ActiveSync can be downloaded free of charge from Microsoft’s web site at no cost.• Create a Shared Folder on the WinCE device and use the following command sequence:- Run- CMD- net use [] [Remote Name] [/user:]- copy \Redist\WinCE 4.0\\Bin\CEServer.exe CEServer.exeAlternatively, you can use a Compact Flash (CF) adapter and write to the CF Configure CEServer.exe to automatically start up when you power on the Windows CE device.Notes:• This step is not mandatory. However, it is advised to do this step, so that CEServer.exe canautomatically start your application after power up.• Check with your vendor for specific information on how to select a program (CEServer.exe) toautomatically execute after power up.4–10 InduSoft Web Studio