WAREMA external venetian blinds with crank and motor operation ...

More documents

Recommendations

Info

Repair/dismantling6 Spare parts/repairsCAUTIONPersonal injury or property damage resultingfrom inappropriate repairs!• The product should only be repaired by aqualified specialist.To ensure that your product operates properly on a continuousbasis and to avoid changing its approved status,use WAREMA spare parts only. Contact a qualified specialistfor further information if necessary.7 Dismantling/disposalCAUTIONPersonal injury or property damage from incorrectdismantling!• The product should only be dismantled bya qualified specialist.Dismantling and re-installation of the product must beundertaken by a qualified specialist in accordance withcurrent guidelines and standards. Be sure to ask the manufacturerfor any missing documents before beginning todismantle or reinstall the product.Should the product no longer be required, ensure that it isdisposed of correctly in accordance with the relevant regulations.Procedure for disposalComponents identified in this manner shouldnot be disposed of with the household trash.[B866096_6] - EN / 01.08.12 Page 14 of 20 Subject to change without notice
Troubleshooting8 TroubleshootingCAUTIONPersonal injury or property damage duringtroubleshooting!• Problems without a reference to a qualifiedspecialist or certified electrician may berectified independently.• Other problems are only to be dealt withby a qualified specialist or certified electrician.Problem Possible causes RemedyMotor is not operating Motor is faulty Motor change (qualified specialists only)Bottom rail does not move to limitpositions On-site motor connection is incorrect Reconnect as per wiring diagram(electricians only) Motor thermal protection switch hastriggered There is no current In the upward direction, the motorswitches off when the allowable torquelimit is exceeded (only with optionalswitch-off unit with special bottom railfor flush cover panel or comfort switchofffor icing) A higher-level control command ispresent Motor limit positions are incorrectWait 10 to 15 minutes, then try againCheck the power fuse (electricians only)Issue a short down command; while theproduct is moving down, stop the unitand check whether the path is blocked. Ifit is, remove the block and issue a downcommand.When the motor stops again, learn themotor into this product again (qualifiedspecialists only).Await switch on/off delayReadjust the motor again (qualified specialistsonly)Slats can be adjusted but blind doesnot move up Guide rail is soiled Lifting tapes are tornBlind moves up and down erratically Lifting tape is torn Blockage in the vicinity of the guideRemove soilingReplace the lifting tapes (qualified specialistsonly)Replace the lifting tapes (qualified specialistsonly)Move the product up and down slightly(or in reverse order) Blockage in the vicinity of the tiltingtapeIf the fault occurs again: Fully raise theexternal venetian blind and inform thequalified specialist.[B866096_6] - EN / 01.08.12 Page 15 of 20 Subject to change without notice
Page 1 and 2: WAREMA external venetian blindswith
Page 3 and 4: Introduction1 Introduction1.1 Infor
Page 5 and 6: Product information2 Product inform
Page 7 and 8: Operation3 Operation NOTEOnly opera
Page 9 and 10: Operation3.3 Operation using the ce
Page 11 and 12: Care/maintenance4 Care/maintenanceG
Page 13: Care/maintenance/warrantyDANGERFunc
Page 17 and 18: EC Declaration of Conformity9 EC De
Page 19 and 20: [B866096_6] - EN / 01.08.12 Page 19

WAREMA external venetian blinds with crank and motor operation ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?