WAREMA external venetian blinds with crank and motor operation ...

TroubleshootingProblem Possible causes RemedyThe crank rod is difficult or impossible The mechanism is blocked or faulty Replace the gear (qualified specialiststo turnonly) Crank or pivot bearing is faulty Hexagonal input shaft is not alignedReplace the pivot bearing (qualified specialistsonly)Rework the drilled hole (qualified specialistsonly)Bottom rail rests on tension cablebracketCoupled blind reacts with a delay ornot at all Hexagonal input shaft is too short forthe drive Tension cable bracket is installed toohigh Coupling of tilt rod is missingReplace the pivot bearing (qualified specialistsonly)Correct the tension cable bracket position(qualified specialists only)Slide coupling tube onto tilt rod of driveblind and tighten the locking screw (qualifiedspecialists only)Tab. 3:Overview of possible problems Locking screw of the coupling tube islooseTighten the locking screw (qualified specialistsonly)[B866096_6] - EN / 01.08.12 Page 16 of 20 Subject to change without notice