WAREMA external venetian blinds with crank and motor operation ...
WAREMA external venetian blinds with crank and motor operation ...
WAREMA external venetian blinds with crank and motor operation ...
- No tags were found...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Troubleshooting8 TroubleshootingCAUTIONPersonal injury or property damage duringtroubleshooting!• Problems <strong>with</strong>out a reference to a qualifiedspecialist or certified electrician may berectified independently.• Other problems are only to be dealt <strong>with</strong>by a qualified specialist or certified electrician.Problem Possible causes RemedyMotor is not operating Motor is faulty Motor change (qualified specialists only)Bottom rail does not move to limitpositions On-site <strong>motor</strong> connection is incorrect Reconnect as per wiring diagram(electricians only) Motor thermal protection switch hastriggered There is no current In the upward direction, the <strong>motor</strong>switches off when the allowable torquelimit is exceeded (only <strong>with</strong> optionalswitch-off unit <strong>with</strong> special bottom railfor flush cover panel or comfort switchofffor icing) A higher-level control comm<strong>and</strong> ispresent Motor limit positions are incorrectWait 10 to 15 minutes, then try againCheck the power fuse (electricians only)Issue a short down comm<strong>and</strong>; while theproduct is moving down, stop the unit<strong>and</strong> check whether the path is blocked. Ifit is, remove the block <strong>and</strong> issue a downcomm<strong>and</strong>.When the <strong>motor</strong> stops again, learn the<strong>motor</strong> into this product again (qualifiedspecialists only).Await switch on/off delayReadjust the <strong>motor</strong> again (qualified specialistsonly)Slats can be adjusted but blind doesnot move up Guide rail is soiled Lifting tapes are tornBlind moves up <strong>and</strong> down erratically Lifting tape is torn Blockage in the vicinity of the guideRemove soilingReplace the lifting tapes (qualified specialistsonly)Replace the lifting tapes (qualified specialistsonly)Move the product up <strong>and</strong> down slightly(or in reverse order) Blockage in the vicinity of the tiltingtapeIf the fault occurs again: Fully raise the<strong>external</strong> <strong>venetian</strong> blind <strong>and</strong> inform thequalified specialist.[B866096_6] - EN / 01.08.12 Page 15 of 20 Subject to change <strong>with</strong>out notice