Prestige Trimax Solo 60175250399 install manual - Coastal Winair

More documents

Recommendations

Info

Combustion Air VentingVentilation and Combustion AirRequirements - Direct VentA Direct Vent appliance utilizes uncontaminedoutdoor air (piped directly to the appliance) forcombustion.For Direct Vent installations, involving onlythe PRESTIGE Solo, in which the minimumservice clearances are maintained as listed onpage 4, no ventilation openings are required.For Direct Vent, zero clearance installationsinvolving only the PRESTIGE Solo, the space/ enclosure must provide two openings for ventilation.The openings must be sized to provide1 square inch of free area per 1,000 BTUH ofboiler input. The openings shall be placed 12inches from the top of the space and 12 inchesfrom the floor of the space.For installations in which the PRESTIGE Soloshares the space with air movers (exhaust fan,clothes dryers, fireplaces, etc.) and other combustionequipment (gas or oil) the space mustbe provided with adequate air openings to provideventilation and combustion air to theequipment. To properly size the ventilation /combustion air openings, the installer mustcomply with the National Fuel Gas CodeNFPA 54, ANSI Z223.1 for installations in theU.S or CSA B149.1 and B149.2 for installationsin Canada.WARNINGThe space must be provided with ventilation/ combustion air openings properlysized for all make-up air requirements(exhaust fans, clothes dryers, fireplaces,etc.) and the total input of all applianceslocated in the same space as the PRES-TIGE Solo, excluding the input of aDirect Vent PRESTIGE Solo which usescombustion air directly from the outside,thus additional free area for the openingsis not required. Failure to provideor properly size the openings couldresult in severe personal injury, death orsubstantial property damage.Ventilation and Combustion AirRequirements - Category IVA Category IV appliance utilizes uncontaminatedindoor or outdoor air (surrounding theappliance) for combustion.BEST PRACTICEIn order to reduce the potential risksassociated with indoor contaminates(listed on page 5), flammable vapors andtight housing construction (little or noinfiltration air), it is recommended topipe uncontaminated combustion airdirectly from the outdoors to the appliance.This practice also promotes highersystem efficiency by reducing heatedindoor air from being exhausted fromthe house and replaced by cold infiltrationair into the house.For installations in which the PRESTIGE Soloshares the space with air movers (exhaust fan,clothes dryers, fireplaces, etc.) and other combustionequipment (gas or oil) the space mustbe provided with adequate air openings to provideventilation and combustion air to the equipment.To properly size the ventilation / combustionair openings, the installer must complywith the National Fuel Gas Code NFPA 54,ANSI Z223.1 for installations in the U.S or CSAB149.1 and B149.2 for installations in Canada,as referenced in this section of the manual andtitled Methods of Accessing Combustion Airinto a Space.WARNINGThe space must be provided with ventilation/ combustion air openings properlysized for all make-up air requirements(exhaust fans, clothes dryers, fireplaces,etc.) and the total input of all appliances,including the PRESTIGE Solo whenlocated in the same space. Failure to provideor properly size the openings couldresult in severe personal injury, death orsubstantial property damage.6
Combustion Air VentingMethods of Accessing Combustion Air Into ASpace - Category IVIndoor Combustion AirNOTICEThe methods listed in this section foraccessing Indoor Combustion Airassume that the infiltration rate is adequateand not less than .40 ACH. Forinfiltration rates less than .40 ACH, referencethe NFPA 54 National Fuel GasCode for additional guidance.Opening Size and LocationOpenings used to connect indoor spaces shallbe sized and located in accordance with thefollowing see Fig. 1:The minimum dimension of air openingsshall be not less than 3 inches.- Combining spaces in different stories.The volumes of spaces in different storiesshall be considered as communicatingspaces where such spaces are connectedby one or more openings indoors or floors having a total minimumfree area of 2 sq. in./1000 Btu/hr oftotal input rating of all gas utilizationequipment.Outdoor Combustion AirBEST PRACTICEIsolating the combustion appliance roomfrom the rest of the building and bringingin uncontaminated outside air forcombustion and ventilation is alwayspreferred.Opening Size and LocationThe minimum dimension of air openings shallbe not less than 3 inchesOpenings used to supply combustion and ventilationair shall be sized and located in accordancewith the following:Fig. 1:All Combustion Air from AdjacentIndoor Spaces Through IndoorCombustion Openings- Combining spaces on the same story.Each opening shall have a minimumfree area of 1 sq. in./1000 Btu/hr of thetotal input rating of all gas utilizationequipment in the space, but not less than100 sq. inches. One opening shall commencewithin 12 inches of the top, andone opening shall commence within 12inches of the bottom of the enclosure.One Permanent Opening Method. See Fig. 2One permanent opening, commencing within 12in. of the top of the enclosure, shall be provided.The equipment shall have clearances of at least 1inch from the sides and 6 in. from the front of theappliance. The opening shall directly communicatewith the outdoors or shall communicatethrough a vertical or horizontal duct to the outdoorsor spaces that freely communicate with theoutdoors and shall have a minimum free area ofthe following:- 1sq. in./3000 Btu/hr of the total inputrating of all equipment located in theenclosures, and7
Page 1 and 2: prestigeSolo 60Solo 175Solo 250Solo
Page 3 and 4: Table of ContentsBoiler System Pipi
Page 5 and 6: Table of ContentsUse of Antifreeze
Page 7 and 8: Product & Safety InformationDefinit
Page 9 and 10: Pre-Installation ItemsSECTION I - P
Page 11: Combustion Air VentingSECTION II -
Page 15 and 16: Combustion Air VentingCombination o
Page 17 and 18: Combustion Air VentingCommonwealth
Page 19 and 20: Unit PreparationsPRESTIGE Solo 60/1
Page 21 and 22: Boiler PipingPressure Relief Valve(
Page 23 and 24: Boiler PipingConnect the expansion
Page 25 and 26: Boiler PipingFig. 7: Near Boiler Pi
Page 27 and 28: Boiler PipingNote: Reference Fig. 2
Page 29 and 30: Boiler PipingFig. 13: Multiple PRES
Page 31 and 32: Installing Vent/Combustion Air & Co
Page 33 and 34: Gas PipingNATURAL GASPipe Sizing -
Page 35 and 36: Gas PipingGas ValveGasketOrificeGas
Page 37 and 38: Internal WiringTriMaxDisplayModuleP
Page 39 and 40: External Wiringcall. This circulato
Page 41 and 42: External WiringCAUTIONLocate the sy
Page 43 and 44: External WiringFig. 21: Multiple Zo
Page 45 and 46: External WiringNote: Reference Fig.
Page 48 and 49: abc de f bbb babc de f bbabc deabc
Page 50 and 51: TriMax OperationStatus Line Message
Page 52 and 53: TriMax OperationEZ SetupNavigation:
Page 54 and 55: TriMax OperationDomestic Hot Water
Page 56 and 57: TriMax OperationCH/DHW OperationNav
Page 58 and 59: abc de f bbb babc de f bbabc deabc
Page 60 and 61: TriMax OperationManual Reset Hard L
Page 62 and 63:
Start-Up PreparationSECTION X - Sta
Page 64 and 65:
Start-Up PreparationCheck For Gas L
Page 66 and 67:
Start-Up ProcedurescccCheck Vent Pi
Page 68 and 69:
Start-Up ProceduresFOR YOUR SAFETY
Page 70 and 71:
External Modulating ControlSECTION
Page 72 and 73:
Check-Out ProceduresSECTION XIV- Ch
Page 74 and 75:
Maintenance SchedulesSECTION XVI -
Page 76 and 77:
Maintenance ProceduresClean Condens
Page 78 and 79:
Maintenance ProceduresCheck Control
Page 80 and 81:
Maintenance Procedures15. Once the
Page 82 and 83:
Replacement Parts65841243Fig. 34: P
Page 84 and 85:
Replacement Parts249351610487Fig. 3
Page 86 and 87:
Replacement Parts2349516410Fig. 38:
Page 88 and 89:
Replacement Parts73847109261Fig. 40
Page 90 and 91:
Product Specifications15 3/8” [39
Page 92 and 93:
Page 94 and 95:
Page 96 and 97:
Product SpecificationsBoilerModelFu
Page 98 and 99:
Product SpecificationsGraph 4: Pres
Page 100:
Additional quality water heating eq
show all

Prestige Trimax Solo 60175250399 install manual - Coastal Winair

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?