Prestige Trimax Solo 60175250399 install manual - Coastal Winair

Installing Vent/Combustion Air & Condensate DrainSECTION V - Installing Vent /Combustion Air & Condensate DrainInstalling Vent and Combustion AirDANGERThe PRESTIGE Solo must be ventedand supplied with combustion air asshown in the PRESTIGE Solo VentSupplement, included in the boilerinstallation envelope. Refer to optionalvent kit instructions for additional ventinstallation instructions. Once installationis completed, inspect the vent andcombustion air system thoroughly toensure systems are airtight and complywith the instructions given in the ventingsupplement and are within all requirementsof applicable codes. Failure tocomply with the installation requirementson the venting and combustion airpiping will cause severe personal injuryor death.Installing Condensate Drain Assembly1. Locate the condensate drain assembly andinstall as shown in Fig. 14 page 25.NOTICEThe installer may want to fill the condensatetrap with water prior to assemblingon the unit.2. Remove the retaining nut and rubber sealfrom the condensate drain assembly andslide over the heat exchanger condensatedrain nipple. Connect the condensate drainassembly to the retaining nut and tighten.Hand tight only!WARNINGEnsure the condensate drain assemblycontains the plastic seated ball. Do notinstall the condensate drain assembly ifthe ball is lost or missing, replace theentire assembly.3. Remove the compression nut and rubberseal from the drain outlet.4. Using 3/4” x 2’ flexible PVC tube provided,slide the compression nut and rubberseal over the pipeNOTICEThe use of 3/4” PVC or CPVC pipe isalso acceptable. If 3/4” pipe is useddeburr and chamfer pipe to allow matingonto the drain assembly.5. Thread the rubber seal into the compressionnut to ease installation of the pipe tothe drain assembly.6. Seat the pipe onto the drain assembly andtighten the compression nut. Hand tightonly!NOTICEThe installer may opt to using 13/16" IDtubing in lieu of rigid piping.NOTICEThe drain line materials must be anapproved material by the authority havingjurisdiction. In absence of suchauthority, PVC and CPVC piping mustcomply with ASTM D1785 or D2845.The cement and primer used on the pipingmust comply with ASME D2564 orF493. For installations in Canada, useCSA or ULC certified PVC or CPVCpipe, fittings and cement/primer.7. Continue the pipe from the drain assemblyto a floor drain or condensate pump.24