KMD-201AA KMD-201AWA - Hoshizaki

9) Evacuate the system, and charge it with refrigerant. For air-cooled and water-cooledmodels, see the nameplate for the required refrigerant charge.10) Attach the expansion valve bulb to the suction line in the same location as the previousbulb. The bulb should be at the 12 o'clock position on the tube. Be sure to secure thebulb with the clamp and holder and to insulate it.11) Place the expansion valve cover in position.12) Replace the panels in their correct positions.13) Turn on the power supply.7. EVAPORATOR1) Turn off the power supply.2) Remove the panels and the front and top insulation.3) Recover the refrigerant and store it in an approved container.4) Remove the spray tubes. Remove the insulation at the "U" shaped notch where therefrigeration tubing passes through the molded chassis.5) Disconnect the evaporator tubing.6) Remove the pop rivets securing the evaporator, then lift out the evaporator.7) Install the new evaporator.8) Remove the drier, then place the new drier in position.9) Braze all fittings while purging with nitrogen gas flowing at a pressure of 20 to 30 kPa.10) Use an electronic leak detector or soap bubbles to check for leaks. Add a trace ofrefrigerant to the system (if using an electronic leak detector), and then raise thepressure using nitrogen gas (970 kPa). DO NOT use R-404A as a mixture withpressurized air for leak testing.11) Evacuate the system, and charge it with refrigerant. For air-cooled and water-cooledmodels, see the nameplate for the required refrigerant charge.12) Replace the removed parts in the reverse order of which they were removed.13) Replace the insulation and the panels in their correct positions.14) Turn on the power supply.36