KMD-201AA KMD-201AWA - Hoshizaki

8) Connect the bin control connector to the side of the control box.9) Replace the water tank, cube guide, pump motor bracket, pump motor and float switch intheir correct positions until they snap in place.10) Secure the pump motor bracket with the two thumbscrews.11) Reconnect the pump motor connector and float switch connector.12) Replace the front insulation and front panel in their correct positions.13) Turn on the power supply.17. THERMISTOR1) Turn off the power supply.2) Remove the panels.3) Disconnect the Connector of the Thermistor lead (orange).4) Remove the Ties, Insulation, Thermistor Holder, and Thermistor in this order.5) Remove the old sealant from the Thermistor Holder and Suction Pipe.6) Wipe off any moisture or condensation from the Suction Pipe surfaces.7) Press a tube of the sealant KE 60RTV, manufactured by Shin-Etsu Silicones, to therecess of the Thermistor Holder. Slowly squeeze the sealant out of the tube and spread itsmoothly in the recess. Do not use any sealant other than the above.8) Attach the new Thermistor in position on the Suction Pipe and press down the ThermistorHolder over the Thermistor. Be careful not to damage the Thermistor lead. Cover theparts with the Insulation and secure them with the Ties. Keep the Thermistor inside theThermistor Holder. After the Thermistor Holder is fitted, do not pull the Thermistor lead tomove the Thermistor.44