You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
pict 1<br />
6. Mounting<br />
For FREE FLEX PLUS:<br />
Connect the two parts of the FREE FLEX-bridge.<br />
The pins must face up and lock in the slots<br />
(pict 2).<br />
pict 2<br />
Place the heel and the Free Flex band over the<br />
prepared holes and fasten the four screws.<br />
Note: For drill template positions up to 31 cm the<br />
FREE FLEX-band cover has to be shortened. For<br />
template positions 32 cm and up no shortening<br />
is needed (pict 3).<br />
pict 3<br />
Connect the FREE FLEX-band cover (1) with the<br />
toe base plate (2) at the position shown on the<br />
drill template boot length indicator (see pict 4).<br />
▲<br />
CONTENTS<br />
pict 4 ❷2 ❷1<br />
Slide the connected parts into the heel plate (1)<br />
until the mounting holes for the toe are aligned<br />
with the prepared holes in the ski.<br />
Connect the toe base plate with the FREE FLEXband<br />
(see pict 5).<br />
Place the toe over the holes and drive the screws.<br />
Turn the eccentric screw (1) 180° clockwise so<br />
the mark on the screw is aligned with the mark<br />
on the plate (see pict 6).<br />
pict 6<br />
Turning the eccentric screw activates the Free<br />
Flex Plus function. Always deactivate the Free<br />
Flex Plus function before dismounting the binding.<br />
LD CYBER:<br />
MOUNTING / 17<br />
Connect the LD CYBER bridge with the CYBER<br />
toe base plate according to centimeter mark<br />
from the drill template (pict 7).<br />
The arrow (2) on the CYBER bridge should point<br />
to the selected centimeter mark (pict 7).<br />
▲<br />
❷1<br />
pict 5
Change language