You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
2. Edge of the release cam under the heel lug as<br />
shown white in the pict below (use TYROLIA<br />
grease, see pict 60).<br />
pict 60<br />
3. Both sides of the heel track (inside), entire<br />
length (use TYROLIA grease).<br />
4. The bearings of the opened hand-lever,<br />
bottom side (use TYROLIA grease, see pict 61).<br />
pict 61<br />
5. The guiding channel of the release setting<br />
adjustment screw (use TYROLIA ServiSpray).<br />
After finishing the heel lubrication restore its<br />
original position and lock it in place.<br />
Not to be Lubricated<br />
The locking element and the corresponding holes<br />
in the heel track should be cleaned but not lubricated.<br />
This could prevent dirt accumulation in this area,<br />
which could interfere with the ease of handling.<br />
Test your Drill Template<br />
A worn or damaged drill template could create a<br />
lot of trouble. Please check your templates periodically:<br />
1. Position the fully extended drill template on a<br />
discarded ski.<br />
2. Turn the clamping lever to open the clamping<br />
jaws of the mounting template.<br />
3. Position the template properly on the ski so<br />
that the boot center marking is aligned with<br />
the mounting point described on the ski.<br />
4. Let go of the clamping lever. The template<br />
clamps automatically.<br />
▲<br />
5. Drill all the holes.<br />
6. Remove the mounting template and clean the<br />
ski.<br />
7. Measure the holes with a slide gauge.<br />
8. The distance of the screw holes to the edge of<br />
the ski must be equal for each pair of related<br />
holes. The deviation must not be more than<br />
1 mm.<br />
9. The mounting template must be discarded if<br />
greater deviations occur!<br />
Repair of damaged Mounting<br />
Holes or broken Screws<br />
For repairing damaged holes, we suggest our<br />
special “Repair Set” – art. nr. 162 127.<br />
It consists of a hollow drill bit and plastic inserts<br />
(pict 62).<br />
pict 62<br />
CONTENTS<br />
You can extract broken screws too.<br />
Remove the binding from the ski.<br />
Drill with the hollow drill through the bushing of<br />
the appropriate drill template and drive in the<br />
plastic insert.<br />
Mount the binding again (pict 63).<br />
Sealing old Mounting Holes<br />
SERVICE/ 53<br />
For sealing old holes you can use wood-plugs or<br />
plastic plugs (art. nr. 160 857), if not otherwise<br />
specified by the ski manufacturer.<br />
▲<br />
pict 63
Change language