Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
RAILFLEX System II<br />
Mounting of the Railflex System II<br />
Make sure that the boot is satisfying the international<br />
standards and has no functional damage.<br />
Determine the boot sole length with the TYROLIA<br />
Rental boot caliper art. nr. 162 617 (pict 34).<br />
Connect the toe and heel with the Railflexband at<br />
the closest sole length mark corresponding to<br />
the measured boot sole length (pict 35).<br />
pict 35<br />
Slide the binding on the Railflexbase from the rear<br />
until the mark on the band cover is aligned with the<br />
selected mark on the center piece (+15/0/-15).<br />
Make sure that all components of the binding are<br />
engaged with the base.<br />
Then fix the binding position by tightening the<br />
screw in the center piece (pict 36).<br />
▲<br />
pict 34<br />
CONTENTS<br />
Detail A<br />
15mm 15mm<br />
RAILFLEX DEMO System<br />
MOUNTING/ 29<br />
Connect the toe with the front of the Railflex<br />
Demo Band by snapping the metal pins of the<br />
toe in the band. Connect the heel with the back<br />
of the Railflex Demo Band by snapping the metal<br />
pins of the heel in the band (pict 37).<br />
pict 37<br />
Slide the binding on the Railflex base from the rear<br />
until the mark on the band cover is aligned with<br />
the selected mark on the center piece (pict 38).<br />
▲<br />
Detail A<br />
pict 36
Change language