Technical Manual - Tyrolia

6. Forward pressure control
Place the boot in the binding and close it. The indicating
pointer should rest within the scribed area
(8). If not lift the tooth lock with a screwdriver, adjust
the forward pressure and lock the tooth lock
again. The adjustment range is +- 4 mm, the last
position to the front and the rear is reached if the
indicating pointer (1) or (2) is aligned with the
rearend of the steel base plate (3) (see pict 42).
Note: Always remove the boot before opening
the toothed lock.
Check the forward pressure again.
7. Adjustment of the release Values
The adjustment value of toe and heel should be
determined by height and body weight (ISO/ASTM)
method. Set the bindings accordingly to the individual
parameters of the skier. We recommend
the use of a calibrated testing device, and that
you keep a written record of whether the system
passes or fails (this is a requirement in the US).
Note: Release/retention settings above a release
moment of 100 Nm at the toe and 400 Nm at the
heel are higher than the international standards
recommend and are used solely at the skiers
own risk!
8. Function Check
Check the function of the heel. Make sure that
the boot does not catch on the heel during entry
and exit.
➊
●➊
➌● ●➋
➋
➑
▲
pict 42
pict 43
CONTENTS
Check the brake function by pressing down the
brake treadle (1) by hand. The brake arms (2)
must open to the braking position when the brake
treadle is released (see pict 44).
➊
Check the elasticity and retention of the toe by
pushing the boot inward and outward. The binding
must recenter the boot easily and quickly from a
15 mm lateral displacement.
9. Final Check
• Is the proper mounting point selected?
MOUNTING / 31
• Are all screws fastened tightly?
• Is the forward pressure properly adjusted?
• Are the release values of toe and heel properly
determined and set?
• Is the Instruction for use booklet ready to be
handed over to the customer?
▲
➋
pict 44