Technical Manual - Tyrolia

Lubricate the new inserts with TYROLIA grease,
clean the heel track, and slide the heel back into
the track. Lock the locking lever into the same
position it was before, remount the brake and
tighten the screws.
For remounting the brake it is necessary that the
cross-bolt of the brake is located under the hooks
of the heel track. The brake has to be in the upright-braking
position (pict 55).
pict 55
Sparepart-Indentification
Most of the replaceable parts have an article
number (000 000) imprinted on the bottom.
Reference this number when you order spareparts
to prevent confusion.
Tapping
TYROLIA recommends tapping the drilled binding
holes of any ski before mounting. Of course, there
is a never-ending discussion among the mechanics
if this is really necessary.
But the pros are convincing:
• smooth and easy mounting
• reduced risk of stripping a screw
• same momentum adjustment of the screwdriver
regardless of the ski material
• increased mounting quality/precision
• fewer pull outs.
POWER BRAKE LD FAT 115 and
LD WIDE 90
art. nr. 162 603 and. art. nr. 162 604
For all skis with a waist width larger than 78 mm
TYROLIA offers extra wide Power Brakes.
The POWER BRAKE LD FAT 115 can be used for
ski with a width up to 115 mm.
The POWER BRAKE LD WIDE 90 can be used for
skis with a width from 79 mm to 90 mm.
It is fully compatible to all bindings with regular
standard power brakes (pict 56).
▲
pict 56
CONTENTS
LD WIDE BRAKE 90
Template “Adapter”-Set
(art. nr. 162 569)
Compatible to all TYROLIA-Template.
Warning: Avoid dropping of the template.
The clamping jaws could be damaged.
59-82 mm
SKI
Ski width
79–90mm
▲
1
LD FAT BRAKE 115
Ski width
91–115mm
50-73 mm
SKI
For skis with integrated our mounted plates.
For wide skis.
2 83-106 mm
SKI
SERVICE / 51
1
2