ULTRA Plus+ 1500 Airless Paint Sprayer - Graco Inc.

SetupWARNINGFIRE AND EXPLOSION HAZARDProper electrical grounding is essentialto reduce the risk of fire or explosionwhich can result in serious injury andproperty damage. Also read FIRE OREXPLOSION HAZARD on page 4.1. Connect gun, 1 m hose (78) and 15 m hose (79).Don’t install spray tip yet.2. Two gun hookup. Remove cap (12) from 1/4npsm(m) secondary hose outlet and attach minimum15 m long hose. For more flexible gun movement,install 3/16 in. ID, 1 m whip hose betweenmain hose and gun.WARNINGIf you supply your own hoses and spray gun, besure the hoses are electrically conductive, thatthe gun has a tip guard, and that each part israted for at least 21.0 MPa (210 bar, 3000 psi)Working Pressure. This is to reduce the risk ofserious injury caused by static sparking, fluidinjection or over-pressurization and rupture ofthe hose or gun.CAUTIONTo avoid damaging the pressure control, which mayresult in poor equipment performance and componentdamage, follow these precautions:1. Always use a nylon spray hose at least 15 m (50ft.) long.2. Never use a wire braid hose as it is too rigid toact as a pulsation dampener.3. Never install any shutoff device between thesprayer outlet (D) and the hose. See Fig. 2.3. Fill packing nut/wet–cup (E)1/3 full with GracoThroat Seal Liquid (TSL), supplied.4. Check electrical service. Be sure electrical serviceis 220 V, 50 Hz. Use properly grounded outlet. Ifplug is wrong, have licensed electrician attachcorrect plug to power supply cord. Do not removegrounding prong of power supply cord. Do not usean adapter. Extension cords must have 3 wires ofminimum 2.5 mm (12 gauge) size. Long extensioncords reduce sprayer performance. Set 10/12 Ampswitch (C) to correct setting.5. With ON/OFF switch (A) OFF, plug cord into agrounded electrical outlet located at least 6 m (20ft.) away from spray area. See Fig. 26. Flush pump to remove lightweight oil which wasleft in to protect pump parts after factory testing.See page 10.12C78E79DB55ADo not install any shutoff device hereFill packing nut 1/3 full with TSL118Fig. 2