GE Fanuc Automation - Platforma Internetowa ASTOR

Chapter
3
Configuration
The TCM is configured using the Logicmaster 90-30 configuration software. Configuring the
TCM is a two-part procedure consisting of:
1. I/O Rack Configuration
2. Module Configuration
I/O Rack Configuration
Module Configuration
The TCM is configured using the Logicmaster 90-30 software in the same way as other Series 90-
30 modules. The software is used to define the type and location of all modules present in the
PLC racks. This is done by completing setup screens which represent the modules in a baseplate
and saving the information to a configuration file, which is then downloaded to the PLC CPU.
Once a baseplate and slot location for the TCM is defined, you can continue to the second part of
the TCM configuration, Module Configuration.
This section is divided into two parts:
1. Setting the Configuration Parameters
2. Definitions of the %Q, %AQ, %I and %AI data parameters and results.
Setting the Configuration Parameters
As with the I/O Rack Configuration, Module Configuration is done by completing screens in the
Logicmaster 90-30 configuration software. The Hand Held Programmer can only configure the
Module and Serial Port Configuration Data.
GFK-1466 3-1