Deluxe 500 - Bulldog Security

.OPERATIONB. ENGINE START MEMORIZING FOR VEHICLES WITH MANUALTRANSMISSIONSThe system senses the neutral transmission position automatically and thereis no prior set-up required. The system in the standard transmission vehicleoperates a process that when you exit the vehicle it senses and memorizesthe neutral transmission position. If the vehicle is equipped with a automatictransmission, this process is omitted.1. While engine is running with ignition key, set the emergency brake andplace the transmission in the neutral position.2. Before turning off the engine, press the button twice on the transmitter.-- The LED indicator will flash 3 times to confirm it is entered.3. Turn off the “Ignition Key” and remove it from the key cylinder.-- The engine will continue running until the pre-programmed time elapsedor a shutdown input is received.--4. Exit the vehicle, close all doors.-- The engine should still continue running, this is a normal operatingprocess.5. Within 1 minute from the time of step 1, press the button on thetransmitter to lock the doors.6-1. If the engine shuts down immediately and the system is now readyfor next remote (or programmable) engine starts.6-2. If the engine does not shut down immediately, the system has failedin engine start memorize set up, repeat above process again.If a door is opened after the above process, the prior memorization forthe next remote or programmed engine start sequence was delete andthe function shall not work until you repeat above process again.Note: If the engine start memorize is set up, the dome lightsupervision function will be temporarily by-passed.C. TO OPERATE THE VEHICLEWHILE RUNNING IN THE REMOTE START MODE:To operate the vehicle while running in the remote start mode:Insert the ignition key and turn it to the “ON” (not the start) position.Press the brake pedal.Note: If the brake pedal is pressed before the key is in the “ON”position, the engine will shut down.15