Gypsy EP ARF Park Flyer - E-flite

More documents

Recommendations

Info

❍ 2. Carefully remove the covering along the linesusing a sharp hobby knife. Be very careful notto cut into the underlying wood and weakenthe stabilizer. If the stabilizer is weakened, itcould fail in flight.❍ 3. Align a straight edge along the bottom of thefin. Use a felt-tipped pen to draw a line ontothe lower front section of the fin. Draw lines onboth sides of the fin.10
❍ 4. Remove the covering from the lower frontsection of the fin 3/16" (5mm) below thelines drawn in the last step. Also make surethere is no covering on the bottom of the finas indicated. Leave the covering on the topforward fin as shown.❍ 5. Place the fin onto the top of the stabilizer.The positioning of the fin will be as far backin the notch as possible, aligned with thecovering removed from the stabilizer, andsquare to the stabilizer. Use medium CA toglue the fin to the stabilizer, keeping in mindthe three alignments.11
Page 1 and 2: Assembly Manual
Page 3 and 4: WarningAn RC aircraft is not a toy!
Page 5 and 6: Optional PartsPark 370 Brushless Mo
Page 7 and 8: Checking the Wing WashoutRequired P
Page 9: Join the Vertical Fin and Horizonta
Page 13 and 14: ❍ 3. Separate the tail assembly f
Page 15 and 16: ❍ 3. Connect the servos and batte
Page 17 and 18: ❍ 7. Secure the servos using the
Page 19 and 20: ❍ 2. Locate one of the control ho
Page 21 and 22: ❍ 7. Slide the micro pushrod keep
Page 23 and 24: ❍ 2. Slide one of the main wheels
Page 25 and 26: Motor Break-inRequired PartsMotorRe
Page 27 and 28: ❍ 4. Press the safety spinner ont
Page 29 and 30: Control ThrowsRequired PartsFuselag
Page 31 and 32: Center of GravityAn important part
Page 33 and 34: Compact enough for any small park,
Page 35 and 36: 3) At all flying sites a straight o

Gypsy EP ARF Park Flyer - E-flite

Create successful ePaper yourself

Delete template?

Save as template?