Gypsy EP ARF Park Flyer - E-flite

More documents

Recommendations

Info

❍ 4. Position the tailskid so the front pin is alignedwith the hole drilled in Step 3. Mark thelocation of the aft pin onto the fuselage using afelt-tipped pen.❍ 5. Drill the location made in Step 4 using a1/8" (3mm) drill bit.❍ 6. Use medium CA to glue the tailskid tothe fuselage.24
Motor Break-inRequired PartsMotorRequired Tools and AdhesivesLow voltage battery sourceIt is suggested to break-in the motor properly andto extend the life of the motor. Place a drop of oilon both the front and rear bushing of the motor,then run the motor for a few minutes on a lowervoltage source, such as 4.8 volts. This will seat thebrushes to the commutator, giving the bestperformance. Apply a drop of oil after every 5–6flights for good measure.Motor InstallationRequired PartsFuselageMotorGearbox w/motor3 x 10mm self-tapping screw (4)Required Tools and AdhesivesPhillips screwdriver❍ 1. Remove the stick mount from thegearbox assembly.25
Page 1 and 2: Assembly Manual
Page 3 and 4: WarningAn RC aircraft is not a toy!
Page 5 and 6: Optional PartsPark 370 Brushless Mo
Page 7 and 8: Checking the Wing WashoutRequired P
Page 9 and 10: Join the Vertical Fin and Horizonta
Page 11 and 12: ❍ 4. Remove the covering from the
Page 13 and 14: ❍ 3. Separate the tail assembly f
Page 15 and 16: ❍ 3. Connect the servos and batte
Page 17 and 18: ❍ 7. Secure the servos using the
Page 19 and 20: ❍ 2. Locate one of the control ho
Page 21 and 22: ❍ 7. Slide the micro pushrod keep
Page 23: ❍ 2. Slide one of the main wheels
Page 27 and 28: ❍ 4. Press the safety spinner ont
Page 29 and 30: Control ThrowsRequired PartsFuselag
Page 31 and 32: Center of GravityAn important part
Page 33 and 34: Compact enough for any small park,
Page 35 and 36: 3) At all flying sites a straight o

Gypsy EP ARF Park Flyer - E-flite

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?