CNXT4236IH - At Andiron Fireplace Shop

More documents

Recommendations

Info

Top Vent—Vertical Termination—No ElbowsNote: If installing a vertical vent/terminationrun off the top of the appliance, the verticaltermination baffl e supplied with the appliancemay be used. See Section E.12 ft (3.66 m) min.60 ft (18.29 m) max.Figure 5.7Vertical Termination - No ElbowsTop Vent—Vertical Termination—Two ElbowsNote: If installing a vertical vent/termination run off the top of theappliance, the vertical terminationbaffl e supplied with the appliance maybe used. See Section E.12 ft (3.66 m) min.60 ft (18.29 m) max.Maximum horizontalrun is 100% ofvertical, but cannotexceed 26 ft (7.92 m)Figure 5.8Vertical Termination - Two Elbows18 Heatilator • Caliber CNXT Series • 4047-132 Rev O • 09/07
Top Vent—Vertical Termination—Three ElbowsNote: Subtract 3 ft (914 mm) from the total horizontalmeasurement for each 90° elbow installed horizontally.Subtract 1-1/2 ft (457 mm) from the total horizontalmeasurement for each 45° elbow installed horizontally.Maximum horizontal run is100% of vertical, but cannotexceed 26 ft (7.92 m)12 ft (3.66 m) min.60 ft (18.29 m) max.Note: If installing a vertical vent/terminationrun off the top of the appliance, the verticaltermination baffl e supplied with the appliancemay be used. See Section E.Figure 5.9Vertical Termination - Three Elbows (some horizontal)Rear Vent—Horizontal Termination—No Elbows18 in. (457 mm) max.Figure 5.10 Horizontal Termination - No ElbowsHeatilator • Caliber CNXT Series • 4047-132 Rev O • 09/07 19
Page 2 and 3: Read this manual before installing
Page 5 and 6: NOTE: The following requirements re
Page 7 and 8: 3Framing and ClearancesNote:• Ill
Page 9 and 10: C. Clearances1/2 in. (13 mm)1/2 in.
Page 11 and 12: 4Termination LocationsA. Vent Termi
Page 13 and 14: HDEVL BFCVVBFixedClosedVBBOpenableF
Page 15 and 16: D. Vent DiagramsWARNINGFire RiskExp
Page 17: Top Vent—Horizontal Termination
Page 21 and 22: Rear Vent—Horizontal Termination
Page 23 and 24: Rear Vent—Vertical Termination—
Page 25 and 26: 4. Squeeze the open end of the bent
Page 27 and 28: C. Install the Ceiling Firestop•
Page 29 and 30: 7Appliance PreparationCAUTIONSharp
Page 31 and 32: • Place outer collar on rear of a
Page 33 and 34: B. Securing and Leveling the Applia
Page 35 and 36: Assemble Pipe SectionsInsert the in
Page 37 and 38: Secure the Vent SectionsVertical se
Page 39 and 40: Install the Horizontal Termination
Page 41 and 42: E. Assemble and Install Storm Colla
Page 43 and 44: WARNINGFire RiskExplosion Risk• G
Page 45 and 46: WARNINGShock Risk• Replace damage
Page 47 and 48: F. Installing the Flame SolenoidGas
Page 49 and 50: I. WSK-MLT Operating InstructionsTh
Page 51 and 52: BatteryOperationSwitchControlBox"OF
Page 53 and 54: 12 Appliance Setup E Lava Rock, Ver
Page 55 and 56: G. Glass AssemblyWARNINGHandle glas
Page 57 and 58: B. Lighting the ApplianceIntellifir
Page 59 and 60: 14 TroubleshootingWith proper insta
Page 61 and 62: 15Maintaining and Servicing the App
Page 63 and 64: 16A. Appliance Dimension DiagramDim
Page 65 and 66: Vent Components Diagrams (con’t)D
Page 67 and 68: Vent Components Diagrams (con’t)1
Page 69 and 70:
Vent Components Diagrams (con’t)F
Page 71 and 72:
Service PartsService Parts List36 i
Page 73 and 74:
Page 75 and 76:
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
Page 85 and 86:
Page 87 and 88:
(D. Optional Components con’t)CNX
Page 89 and 90:
This page intentionally left blank.
Page 91 and 92:
E. Limited Lifetime WarrantyGas App
show all

CNXT4236IH - At Andiron Fireplace Shop

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?