CNXT4236IH - At Andiron Fireplace Shop

More documents

Recommendations

Info

E. Installing Vertical Termination BaffleNote: For vertically terminated installations only.3. Part of the refractory must be removed before installingthe vertical baffl e.• Remove the four screws holding the refractory retainersin place. See Figure 5.19.Note: If installing a vertical vent/termination run off thetop or rear of the appliance, the vertical termination baffl esupplied with the appliance may be used.1. Remove the glass (refer to Section 12.H.) to access thefi rebox and 5 in. inner fl ue.2. Fold the baffle (Figure 5.17) to an approximate 90° angle(see Figure 5.18).Figure 5.19 Remove Refractory Retainers• Remove the retainers.• Remove the right or left side refractory (only one sidemust be removed) by gently raising the front of thetop refractory and lifting the side piece up slightly andpulling out. See Figure 5.20.Figure 5.17 Flat BafflePush & hold thefront edge up.Figure 5.20 Remove One Side RefractoryFigure 5.18 Baffle Bent to 90° Angle• Remove top by gently lowering toward side justremoved and gently twisting out. See Figure 5.21.Figure 5.21 Remove Top Refractory24 Heatilator • Caliber CNXT Series • 4047-132 Rev O • 09/07
4. Squeeze the open end of the bent baffl e with one hand.Insert the baffl e bent side up into the inner fl ue so thatthe bottom of the baffl e is above the bead on the insideof the collar. See Figure 5.22.Figure 5.22 Placing the Baffle5. Release pressure on the baffle so that it is wedged againstthe sides of the fl ue collar. See Figure 5.23.Figure 5.23 Baffle in Place6. Reinstall refractory in reverse order of removal (see#3).7. Replace the glass (refer to Section 12.H.).8. Start the appliance.Heatilator • Caliber CNXT Series • 4047-132 Rev O • 09/07 25
Page 2 and 3: Read this manual before installing
Page 5 and 6: NOTE: The following requirements re
Page 7 and 8: 3Framing and ClearancesNote:• Ill
Page 9 and 10: C. Clearances1/2 in. (13 mm)1/2 in.
Page 11 and 12: 4Termination LocationsA. Vent Termi
Page 13 and 14: HDEVL BFCVVBFixedClosedVBBOpenableF
Page 15 and 16: D. Vent DiagramsWARNINGFire RiskExp
Page 17 and 18: Top Vent—Horizontal Termination
Page 19 and 20: Top Vent—Vertical Termination—T
Page 21 and 22: Rear Vent—Horizontal Termination
Page 23: Rear Vent—Vertical Termination—
Page 27 and 28: C. Install the Ceiling Firestop•
Page 29 and 30: 7Appliance PreparationCAUTIONSharp
Page 31 and 32: • Place outer collar on rear of a
Page 33 and 34: B. Securing and Leveling the Applia
Page 35 and 36: Assemble Pipe SectionsInsert the in
Page 37 and 38: Secure the Vent SectionsVertical se
Page 39 and 40: Install the Horizontal Termination
Page 41 and 42: E. Assemble and Install Storm Colla
Page 43 and 44: WARNINGFire RiskExplosion Risk• G
Page 45 and 46: WARNINGShock Risk• Replace damage
Page 47 and 48: F. Installing the Flame SolenoidGas
Page 49 and 50: I. WSK-MLT Operating InstructionsTh
Page 51 and 52: BatteryOperationSwitchControlBox"OF
Page 53 and 54: 12 Appliance Setup E Lava Rock, Ver
Page 55 and 56: G. Glass AssemblyWARNINGHandle glas
Page 57 and 58: B. Lighting the ApplianceIntellifir
Page 59 and 60: 14 TroubleshootingWith proper insta
Page 61 and 62: 15Maintaining and Servicing the App
Page 63 and 64: 16A. Appliance Dimension DiagramDim
Page 65 and 66: Vent Components Diagrams (con’t)D
Page 67 and 68: Vent Components Diagrams (con’t)1
Page 69 and 70: Vent Components Diagrams (con’t)F
Page 71 and 72: Service PartsService Parts List36 i
Page 73 and 74: Service PartsService Parts List36 i
Page 75 and 76:
Service PartsService Parts List36 i
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
Page 85 and 86:
Page 87 and 88:
(D. Optional Components con’t)CNX
Page 89 and 90:
This page intentionally left blank.
Page 91 and 92:
E. Limited Lifetime WarrantyGas App
show all

CNXT4236IH - At Andiron Fireplace Shop

Create successful ePaper yourself

Delete template?

Save as template?