CNXT4236IH - At Andiron Fireplace Shop

WARNINGShock Risk• Replace damaged wire with type 105°C rated wire.• Wire must have high temperatureinsulation.E. WSK-MLT Multifunction Wall SwitchThe WSK-MLT multifunctional wall switch is designed tocontrol fl ame height, blower speed and auxilary functions onyour gas fi replace. For models equipped with the intellifi resystem (*IPI), the cold climate function can control the pilotfl ame as well. The wall switch is equipped with thermostatfunctions which can automatically control the temperaturein the room in which it is installed. An auxiliary function provides110-120 VAC source for added features the fi replacemay have installed. Electrical ratings for the control box are110 VAC, 60 Hz, and is required for operation of this device.PrecautionsThis remote is tested and safe when installed in accordancewiththis installation manual. It is your responsibility to readall instructions before starting installation and to follow theseinstructions carefully during installation. Do not install anycomponents that may be damaged. Do not modify, disassemble,or substitute any of the components included withthis kit. Installation of this unit must be done by a qualifi edservice technician.Placement of this wall switch may affect performance or accuracyof the automatic (thermostat) control. An assessmentof the space should be done prior to installation for optimalperformance. See “Determine Location” for recommendations.Determine LocationDetermine the location for the wall switch. The chosen locationshould provide an accessible location in the same spaceas the gas fi replace. Never place this unit in a separateroom. The control wire supplied with this unit is 17 ft (5.2 m)in length. The distance from the fi replace to the switch maybe lengthened provided that the wire used never exceeds50 ft, and that the distance from the fi replace to the switchnever exceeds 30 ft.The switch should be mounted into a listed electrical junctionbox. The junction box should be dedicated to this wallswitch. Never install this wall switch into a junction box thatis shared with other electrical service or devices. If possible,install this unit on an interior wall of the residence at a recommendedheight of 5 ft from the fl ooring. Should the switchbe installed on an exterior wall, be certain wall insulation iskept intact and not damaged or dislodged during the installationof the electrical junction box.For exterior wall installations, it is recommended that thejunction box be sealed with caulking material. This will minimizeheat loss through this location and improve the accuracyof the automatic (thermostat) operation.Note: The electrical junction box provided with the fireplacemust be wired with 110 VAC before installing this kit.All wiring should be done by a qualifi ed electrician and shallbe in compliance with local codes and with the NationalElectric Code ANSI/NFGA No. 70- current (in the UnitedStates), or with the current CSA C22.1 CANADIAN ELEC-TRIC CODE (in Canada).Heatilator • Caliber CNXT Series • 4047-132 Rev O • 09/07 45