Maintenance & Inspection Guide - Johnstech

Pad ROL 100ARECOMMENDED TOOLSFor installing and maintaining Johnstech Contactors:• Screwdriver with Allen-Head Bits for fastening the contactor to the load board.• 10X Eye Loupe for magnified inspection of contactor, elastomers and contacts.• Elastomer Tool for use in elastomer installation as well as prying alignment plate from contactor.• Fine-Tip Non-Metallic Tweezers for handling contacts and elastomers.• Scalpel for marking elastomer lengths.• Micro Scissors for cutting elastomers to length.• Probe Tool for use in elastomer Installation.• Fiberglass Brush and Replacement Tips recommended for cleaning the contacts (Iffiberglass brushes are not allowed on the test floor, although not optimum, nylon brushes can besubstituted.)Extras:• Finger Cots recommended to prevent contaminating contactor components with skin oils.• Protective Eye wear recommended to protect technicians from test floor/contactor components,compressed air and other chemicals.CAUTION: Avoid touching the device and load board interface surfaces of thecontacts with metal tools. Scratches on these areas may degrade performance.Recommended Tools (in orderat right)Johnstech’s Maintenance & Inspection KitJohnstech’s Maintenance & Inspection Kit contains many of the tools neededfor maintenance and inspection and are designed especially for Johnstech HighPerformance Contactors. Contact your Johnstech Representative for moreinformation.Maintenance Kit Part Numbers:• with torque screwdriver: 706449• without torque screwdriver: 706448www.johnstech.com©2012 Johnstech International CorporationAll rights reserved.7