1961-63 Thunderbird - Classic Auto Air

More documents

Recommendations

Info

Turn condenser over so that fittings are onthe right side.Attach top condenser brackets to top holeof the condenser, using #10 screwsLocate the drier, drier mounting bracket, pressure switch, (1) #6 liquid tube (short),(1) liquid tube(long), (4) #6 o-rings and (2) #10 x 3/8” hex screws.Attach discharge tube to #8 fittingon condenser using an o-ring and afew drops of mineral oil.Attach short liquid tube to #6fitting on condenser using o-ringand a few drops of mineral oil.Other end attaches to the to thedrier inlet.PRESSURE SWITCHUse the tube to locate drier andmounting bracket. Attach using#10 screws.Attach long liquid tube to the drierusing a #6 o-ring and a few dropsof mineral oil.Slide condenser between radiator and the radiator bulkhead.Let condenser hange on the upper brackets.Install pressure switch on filter drier. Attach the electricalboot to the pressure switch, route white wires across thedischarge tube. Tywrap wires to the tube.18
Locate left bottom condenser mounting bracket and slideinto the bottom radiator mounting bolt.Attach right bottom condenser mountingbracket over the 5/16” bolt.Tighten the condenser bolts.Locate (1) 3/8” tube clamp and (1)#10 x ¾” tek screw.Attach liquid tube to the radiator support usingclamp and screw.REINSTALL RADIATOR FAN AND SPACER USING THE ORIGINAL HARDWARE.19
Page 1 and 2: specializing in “AIR CONDITIONING
Page 3: specializing in “AIR CONDITIONING
Page 6 and 7: Carefully snap off chrome framearou
Page 8 and 9: Locate the drain tube template on l
Page 10: Locate (2) control cables and (2) 3
Page 13 and 14: Insert a/c tubes and heater hoses t
Page 16: Reinstall passenger side dash panel
Page 21 and 22: Locate (2) white wires tywraped to

1961-63 Thunderbird - Classic Auto Air

Create successful ePaper yourself

Delete template?

Save as template?