You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Locate the drain tube template on last page of the instructions.Tape template on the firewall. Locate the original heatermounting hole. Align template to this hole and along bend in thefirewall.Drill a ¾” diameter hole as shown.CUT WIRES HERELocate wire harness that was attached to the controls.Peel tape back all the way to the junction. Separate the lightwire. Cut switch wires at the junction.Also cut off the resistor wires and plug.RESISTORWIRESLocate wire assembly that was attached to the blower motor.Cut the black wire off.Remove the bullet connector and attach (1) ¼” male spadeconnector. Both wires will be crimped into the sameconnector.8
Change language