1961-63 Thunderbird - Classic Auto Air

More documents

Recommendations

Info

Carefully snap off chrome framearound the control head.Retain for reinstallation.Remove (4) screws holding the controlhead to the center mounting plate.Remove center mounting plate andretain hardware.Disconnect electrical harness from the heater box.ELECTRICAL PLUGDrain radiator. Disconnect heater hoses at the firewall.It is recommended that you replace the heater hose from theengine at this time.6
Remove blower motor access cover andremove (4) nuts that attach the heater box tothe firewall. Next picture shows location ofthe nuts. Retain original screws discard thenuts.CAREFULLY REMOVE HEATER ASSEMBLYFROM UNDER THE DASH. DISCARD HEATERASSEMBLY.Locate air inlet flange assemblydirectly above the passenger kickpanel.Remove (4) screws and discard theinlet flange.Locate in the kit the inlet block offplate. Attach plate to the inlet holeusing (4) #10 tek screws supplied.Locate the firewall block off plate.Attach over blower access hole using (1)¼” – 20 bolt and nut through the originalheater mounting hole.Other (4) screws are the original coverfasteners.¼ - 20 x 5/8”BOLT & NUTTTACH OVERMatch drill holes into the firewall thatthe heater hoses will pass through. (13/8” dia)Install grommets over the holes.(2) HOSE GROMMETS7
Page 1 and 2: specializing in “AIR CONDITIONING
Page 3: specializing in “AIR CONDITIONING
Page 8 and 9: Locate the drain tube template on l
Page 10: Locate (2) control cables and (2) 3
Page 13 and 14: Insert a/c tubes and heater hoses t
Page 16: Reinstall passenger side dash panel
Page 19 and 20: Locate left bottom condenser mounti
Page 21 and 22: Locate (2) white wires tywraped to

1961-63 Thunderbird - Classic Auto Air

Create successful ePaper yourself

Delete template?

Save as template?