vector 1800 mt - Sunbelt Transport Refrigeration

WARNINGBe aware of HIGH VOLTAGE supplied by thegenerator as the unit may startautomatically. Before servicing the unit,make sure the START/RUN -OFF switch is inthe OFF position. Also disconnect thenegative battery cable. NEVERdis -assemble the generator: HIGHMAGNETIC FIELD INSIDE!WARNINGUnder no circumstances should ether orany other starting aids be used to start engine.WARNINGWhen performing service and/or maintenanceprocedures, make certain the unitis disconnected from the power sourceand that the RS is in OFF position so thatit is impossible for the unit to start up automaticallyduring the maintenance operation.WARNINGMake sure the power plug is clean and drybefore connecting to any electrical outlet/-receptacle.WARNINGDo not connect to any electrical outletwithout checking that it meets the460/3/60 and 30 Amp electrical requirements.WARNINGAlways place RS in the OFF position andturn off the high voltage power supply beforedisconnecting the high voltage powerplug from the unit.WARNINGDo not place the Start/Run -OFF Switch(RS) in the Start/Run position or the unit willstart.WARNINGDo Not Allow Jumper Wire To Touch AnyGround.WARNINGVoltage will be applied to high voltage components(i.e. the fan motor contactor) andthose components will operate (i.e. the fanblades will turn) when those componentsare energized and the unit is in standby operationand using component test mode.WARNINGCarefully protect eyes from solvent.WARNINGDo not direct water or steam into the generatoropenings. Do not allow any soap andwater solutions to enter the generator.WARNINGHigh voltage (dielectric) testing must not beperformed to the machine without first observingNEMA rules. The insulation of thisgenerator winding may be safely checkedby using a megohm meter. A high readingindicates good insulation.62-110391--2