vector 1800 mt - Sunbelt Transport Refrigeration

CAUTIONUse only ethylene glycol anti-freeze (withinhibitors) in system as glycol by itself willdamage the cooling system. Always addpre-mixed 50/50 anti-freeze and water to radiator/engine.Never exceed more than a60% concentration of anti-freeze. Use a lowsilicate anti-freeze meeting GM specificationsGM 6038M for standard life coolant oruse Texaco Havoline extended life coolantor any other extended life coolant which isDexcool approved and has 5/150 (5years/150,000 miles) on the label.CAUTIONWhen changing oil filters, the new filtersshould be primed (partially filled) with cleanoil if possible. If the filters are not primed,the engine may operate for a period with nooil supplied to the bearings.CAUTIONThe mica shim must be used during disassemblyof the generator from the engine.Never attempt to remove the rotor from thestator. Leave the shim in place until the generatoris re installed on the engine.CAUTIONExtreme care must be taken to ensure themanifold common connection remains immersedin oil at all times; otherwise, air andmoisture will be drawn into compressor.CAUTIONDo not vapor charge R404a systems. Onlyliquid charging through the receiver outlet(King) valve is acceptable.CAUTIONThe +5.0 VDC (terminal B) is common betweenthe Compressor Discharge PressureTransducer, the Compressor Suction PressureTransducer, and the RPM sensor. Ifthis circuit is shorted to ground (due to oneof the mentioned components being defective,or a worn wire) the MessageCenter willshow:Suction Pressure: -29.9inHg ( -1 Bar)Discharge Pressure: 0 Bar/PSIGEngine RPM: 0.62-110391--4