Model 24923 Installation Guide - Ready Remote

More documents

Recommendations

Info

Feature menusDefault settings are in bold type.Menu 1Feature # Feature Opt. 1 Opt. 2 Opt. 3 Opt.4 Opt. 5+1 Horn function Off Siren20 mS2 Ignition controlled OnOfflock3 Ignition controlled OnOffunlockSiren30 mS4 Doorlock output 0.8 sec. 3.5 sec. 0.4 sec.duration5 Double pulse OffOnunlock6 Double pulse lock Off On7 Factory AlarmDisarm function8 Factory AlarmDisarm PulseswithunlockSingleBefore unlockDouble<strong>Remote</strong> start only9 Comfort Closure Comfort Off Comfort Closure 2Closure 110 Panic On OffSiren 40 mSSiren 50 mS1. Horn Function1. Off: turns the lock/unlock horn honk output off, but Panic is still active for 60 seconds2. On: Opt 2-5, 20-50 mS: sets the lock/unlock horn honk output duration2. Ign-controlled Lock1. On: door lock output will activate when ignition is turned on.2. Off: door lock output will not activate when ignition is turned on.3. Ignition Controlled Unlock1. On: door unlock output will activate when the ignition is turned off.2. Off: door unlock output will not activate when the ignition is turned off.4. Door Lock Output Duration1. 0.8sec.: the door lock/unlock pulses for 800mS2. 3.5sec.: the door lock/unlock pulses for 3.5 seconds3. 0.4 sec.: the door lock/lock pulses for 400mS5. Double Pulse Unlock1. Off: unlock output pulses once2. On: unlock output pulses twice6. Double Pulse Lock1. Off: lock output pulses once2. On: lock output pulses twice7. Factory Alarm Disarm function1. With Unlock: Factory Alarm Disarm wire pulses as programmed, at the same time as the unlock(Blue) wire, and when remote start is activated.2. Before Unlock: Factory Alarm Disarm wire will pulse as programmed before the unlock wire, and28© 2010 Directed Electronics. All rights reserved.
when remote start is activated.3. <strong>Remote</strong> start only: Factory Alarm Disarm wire will pulse as programmed during remote start only8. Factory Alarm Disarm pulses1. Single: Factory Alarm Disarm wire pulses once per operation2. Double: Factory Alarm Disarm wire pulses twice per operation9. Comfort Closure1. Comfort Closure 1: door lock pulse (or 2nd pulse for double pulses) will remain on for 20 seconds.2. No comfort Closure: Comfort Closure is defeated when locking3. Comfort Closure 2: 800mS following the end of the door lock pulse (or 2nd pulse for double pulses);door lock output will turn on again for 20 seconds.10. Panic Mode1. On: Panic output can be activated at any time2. Off: Panic output is defeated© 2010 Directed Electronics. All rights reserved.29
Page 1 and 2: Model 24923Installation Guide© 201
Page 3 and 4: ContentsImportant information .....
Page 5 and 6: Installation overviewBe sure to rea
Page 7 and 8: Wiring connectionsMain Harness (H1)
Page 9 and 10: Ground wireH1/8 BLACK GROUNDThe BLA
Page 11 and 12: Accessory and starter wiresH2/2 PUR
Page 13 and 14: Additional heavy gauge harness wire
Page 15 and 16: Safety Shutdown WiresH3/3 BROWN (+)
Page 17 and 18: Type A: Three-wire (+) pulse contro
Page 19 and 20: Caution! If these wires are not con
Page 21 and 22: Type G: Positive (+) multiplexThis
Page 23 and 24: Mounting the antennaThe antenna pos
Page 25 and 26: Reset and deletionIf a feature/Virt
Page 27: Programming system featuresThe Syst
Page 31 and 32: 7. Accessory output1. Off: the Acce
Page 33 and 34: 4. Is an ignition or accessory outp
Page 35 and 36: Using the SystemNote: Horn function
Page 37 and 38: Government RegulationsThis device c
Page 39 and 40: Safety checkBefore vehicle reassemb

Model 24923 Installation Guide - Ready Remote

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?