12.07.2015 Views

Razz plus - Hot Tubs, Hot Tub

Razz plus - Hot Tubs, Hot Tub

Razz plus - Hot Tubs, Hot Tub

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

OPERATIONBasic Control Set-Up (Continued)• Make sure the circuit protector buttons are pushed in.• Locate the HIGH TEMPERATURE SAFETY SWITCHwhich is a raised button on the end of the heater. Pushthis button to be sure it is in the reset mode. Thepurpose of this switch is to shut down the spa if thewater becomes excessively hot. If, for some reason,the switch is tripped, the reset button must be pushedin for the heater to operate again after the water hascooled to about 100 O F.• Set the built-in timer (see below). Use of the timerallows two modes of operation: timed HTR/FLTR andtimed FILTER . With the SYSTEM switch turned OFFSetting the TimerThe built-in 7-day timer is located in the SystemControl Module. The tooth-like tabs that are located onthe dial can be set to activate the filter system for twohourperiods on any day(s) of the week. First set thecorrect time. Set the time of day by rotating the outer dialand aligning the correct time with the small arrow in theinside of the dial. Note: Both correct time and day mustSYSTEM CONTROL MODULEGFCICIRCUITPROTECTORBUTTONSHIGH TEMPERATURESAFETY SWITCHFIELD WIRING BOXFOR 230 VOLTINCOMING POWERPLUG-INCONNECTORSBOND BARTIMERbe set. Next slide one of the tabs toward the center ofthe dial at the time at which you wish the filter system tooperate. Note that the timed mode can begin at any timeof day or night on any specified day of the week.Note: If filtration is being controlled by the timer but youdo not want the water heated to a higher temperature,adjust the HEATER knob to its lowest setting. Becausethe thermostat is connected in this circuit, the heater willmaintain a minimum water temperature.CONTROLSA switch panel giving you convenient control of thejets, filter, HTR/FLTR, light and air blower is located onthe spa rim.To ensure your safety and allow easy operation, yourspa is equipped with two air-activated switches. TheSYSTEM switch, controls the whirlpool jets, heat, andfiltration. The other switch, ACCESSORY controls theTIMERPUSH IN ONE TABFOR EACH TWOHOUR PERIOD OFOPERATIONM o n d a yTu e s d a ySundayWednesdaySaturdayThursdayFriday7

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!