Razz plus - Hot Tubs, Hot Tub

ALEVELSPA SHELLWEIR BLADELeveling the CascadeFirst make sure spa is in its final position and thatit is level before proceeding.To ensure an equal flow of water over the cascadeweir it may be necessary to level the weir blade. (Seeillustration A above.) Loosen the three screws thatsecure the weir blade to the spa shell; then proceed tolevel the weir blade by placing a small level on top of theweir blade. When the blade is level, tighten the screws.Recheck for level after the screws are tightened.If you do not have a level, an alternative method is tofill the spa to its normal water level. Before turning on thespa, loosen the three screws that secure the weir bladeto the spa just enough to be able to adjust the weir blade.Turn on the spa to filter or jet mode. As the water isrunning over the weir blade, adjust the weir blade byhand until there is an even flow of water cascading overthe entire width of the weir blade. After making sure youhave an even flow of water, turn off the spa and tightenthe three screws.Optional 1-1/2" Permanent DrainIf you wish to connect a permanent drain line to the 1-1/2" plumbing of the spa, you may modify the plumbingas shown in illustration B on this page. Note that noneof the piping required for the modification is provided.BAS SUPPLIED FOR HOSE CONNECTION:CUTCAP3/4" BALLVALVEALTERNATE PERMANENT SYSTEM:1-1/2" PVC PIPE1-1/2" BALLVALVE19