Razz plus - Hot Tubs, Hot Tub

OPERATIONair blower and light. Refer to the Control Panel illustrationfor an explanation of the various switch functions.SYSTEMThe SYSTEM switch controls the following four functionsin the continuous sequence indicated:1. OFF2. JETS3. HTR/FLTR4. FILTER(The next selection is OFF again.)Use the JETS function as a reference to indicate yourlocation in the function sequence, since that function isthe most obvious when operating.For best performance and increased equipment life,pause a second or two between push-button selections.Not pausing may cause the switch to malfunction.ACCESSORYcontinuous sequence indicated:1. OFF2. AIR3. AIR/LIGHT4. LIGHTTemp. ControlTurn on the heater by selecting the HTR/FLTR modewith the SYSTEM switch.With this selection, you can verify that the spa’sheater is operating by viewing the indicator light on thespa control panel.(The next selection is OFF again.)The ACCESSORY switch controls these functions in theOFF(Time clock controlsfilter pump. Heater will turnon with filterpump if thermostat is set.)JETS(Maximum whirlpoolaction. Heater willmaintain temperature setby thermostat if convertedto 230 VAC.)HTR/FILTER(Filter pump and heaterwill turn on as necessaryto maintain watertemperature setting.)TEMP.CONTROLKNOBTEMPERATUREREADOUTSACCESSORY SWITCH(Controls Air Blower andlight functions.)SYSTEM SWITCH(Controls Jets,Heater/Filter and FliterOnly functions.)FILTER(Filter pump will runcontinuously; heater willturn on as necessary tomaintain watertemperature setting.)HEATERINDICATORLIGHTBATTERY8