Nortel IP Phone 1120E/1140E User Guide (CICM) - Northwestern ...

Northwestern University Information Technologywww.it.northwestern.edu1. Before you press a line key or lift the handset, use the dial-pad to enter the number.The number is entered into the terminal.2. When you want to make the call, press Ok. The number is dialed.3. When the call is answered, begin speaking.Editing a Pre-dialed NumberFollow this procedure to edit a number held in the pre-dialed state. A number must bepre-dialed before following the steps below.1. Perform one of these steps.• To delete numbers that appear to the left of the cursor, press Bkspc.• To delete numbers that appear to the right of the cursor, press Delete.2. Use the dial-pad to enter the new number.Dialing from the DirectoryFollow this procedure to dial from a Directory entry.1. Make sure the Handset is in the cradle position.2. Press the Directory key. The Directory screen appears, showing a list of storedentries.3. Select a number from the list.4. Press Ok. A list of options appears.5. Press Ok again. The number is dialed.Answering CallsFollow these procedures to answer calls. Incoming calls cause the telephone to soundand the message indicator lamp to flash..Answering a CallFollow this procedure to answer a call.Perform one of these actions to answer a call:• Lift the handset.• To answer a call using the hands-free feature, press the hands-free key.• To answer a call while wearing a headset, press the headset key.Answering a Second CallFollow this procedure to answer a call when you are engaged in a call. If another callcomes in while the primary line is engaged, the phone sounds and a message indicatoricon on the display flashes. While the indicator is flashing you have the opportunity to putthe first call on hold and answer the second call.Nortel 1120e-1140e User Guide Page 9 2/18/2008