Aqualab english manual

• No decompression dive modeThe following data applies to dives that do not exceed the no decompression limit.• Maximum depth:This shows the maximum depth measurement since the start of the dive.• No decompression limit:This shows the maximum amount of time allowable at the current depth withno decompression, calculated based on dive data so far.• Decompression dive modeThe following data applies to dives that exceed the no decompression limit.• Decompression stop depth:Decompression stop depths include 49 feet (15 meters), 39 feet (12 meters),30 feet (9 meters), 20 feet (6 meters), and 10 feet (3 meters).The stop depths are set according to the current dive data and are shown in asequence from deepest to shallowest.• Decompression stop time:This shows the amount of decompression time at each decompression stop depth,calculated based on the current dive data.The amount of decompression time is counted down at each decompression stop depth.• Total ascent time:This shows the total amount of time required for ascent to the surface, calculated basedon the decompression stops and an ascent rate of 24 feet per minute (8 meters perminute).**For further information on the different ascent rates see page 25The display alternates between decompression stop time and total ascent timewhen the total ascent time becomes a three-digit value while thedecompression stop depth remains unchanged.23