Aqualab english manual

TroubleshootingThe following list includes diagnostic tips for when the dive computer appears to bemalfunctioning.Contact the Seac Diving Pro s.r.l regarding any problems that are not included in this list.PROBLEMDECO mark, decompression stopstep, and decompression stop timedisplays blink when at surfaceAll displays blink when at surfaceThe altitude rank symbols keep "E"even though the dive computer iswithin the altitude measurementrange. ( 0,0 to 6.000 meters).The altitude rank display keepschanging.Some data has already beenrecorded in the dive log.The display contents are faded.CAUSES – PREVENTION - RESPONSE• This is caused by a decompression stop violationwarning.If less than five minutes have elapsed at thesurface, return to the displayed decompressionstop depth.• If more than five minutes have elapsed at thesurface, the AQUALAB dive computer will beunusable for 48 hours, after which it isautomatically reset• This is caused by an out of measurement rangewarning.• The dive computer will be unusable for 48 hours,after which it is automatically reset.• This is a malfunction.• Send the dive computer to the Seac Diving pro s.r.lfor repair.• This occurs when the altitude measurement is nearthe borderline between ranks. It is not amalfunction.• This may also occur when the dive computer is in avery hot environment. Cool off the dive computer,such as by immersing it in water.• If neither of the above applies, there may be amalfunction.• Send the dive computer to the Seac Diving Pro s.r.lfor repair.• That data is left over from the chamber tests thatwere conducted at the factory before shipping theproduct.• Such fading can occur in low-temperatureenvironments. Returning the dive computer to awarmer environment should solve the problem.• It may also mean that the battery level is low.• Have the Seac Diving pro s.r.l replace the battery.The computer will not switch to divemode.• This occurs when a decompression stop warning orout of measurement range warning has beendisplayed.The computer will reset itself automatically after48 hours.• It also occurs when the battery life is used up andthe low battery indicator is blinking.• Have the Seac Diving pro s.r.l replace the battery.• When diving at a high altitude, this may occur if thealtitude rank symbols are "E".The computer will reset itself when it is back at alower altitude.34