INSTALLATION & OPERATING INSTRUCTIONS ... - Johnstone Supply

These instructions are also on the furnaceLIGHTING INSTRUCTIONSFOR YOUR SAFETY READ BEFORE OPERATINGA. This appliance does not have a pilot. Itis equipped with an ignition device whichautomatically lights the burners. Do nottry to light the burners by hand.B. BEFORE OPERATING smell aroundthe appliance area for gas. Be sure tosmell next to the floor because some gasis heavier than air and will settle on thefloor.WHAT TO DO IF YOU SMELL GASDo not try to light any appliance.Do not touch any electric switch;do not use any telephone in yourbuilding.Immediately call your supplierfrom a neighbor's phone. Followthe gas suppliers instructions.1. STOP! Read the safety informationabove on this label.2. Set the thermostat to lowest setting.3. Turn off all electric power to the appliance.4. This appliance is equipped with anautomatic ignition system which automaticallylights the burners. Do not try tolight the burners by hand.5. Remove control access panel.6. Move the gas control switch or knobto "OFF".GAS CONTROLKNOB10. Turn on all electric power to theappliance.TO TURN OFF GAS TO APPLIANCE1. Set the thermostat to its lowest setting.2. Turn off all electric power to theappliance if service is to be performed.3. Remove control access panel.If you do not follow these instructions exactly,a fire or explosion may result causing propertydamage, personal injury or loss of life.OPERATING INSTRUCTIONSGAS CONTROLSWITCH SHOWNIN "ON" POSITIONIf you cannot reach your gas supplier,call the fire department.C. Use only your hand to move the gascontrol switch or knob. Never usetools. If the gas control switch or knobwill not operate, don't try to repair it,call a qualified service technician.Force or attempted repair may result ina fire or explosion.D. Do not use this appliance if any parthas been under water. Immediately calla qualified service technician to inspectthe appliance and to replace any part ofthe control system and any gas controlwhich has been under water.7. Wait five (5) minutes to clear out anygas. If you then smell gas, STOP!Follow "B" in the safety informationabove on this label. If you don't smellgas, go to the next step.8. Move the gas control switch or knobto "ON".9. Replace control access panel.11. Set the thermostat to the desiredsetting.12. If the appliance will not operate,follow the instructions "To Turn Off GasTo Appliance" and call your servicetechnician or gas supplier.GAS CONTROLSWITCH SHOWNIN "ON" POSITION4. Move the gas control switch or knobto "OFF". Do not force.5. Replace control access panel.WARNING: Improperinstallation, adjustment,alteration, serviceor maintenance cancause injury or propertydamage. Refer tothe user's informationmanual provided withthis furnace. For assqualifiedinstaller, ser-istance or additionalinformation consult avice agency or thegas supplier.This furnace must beinstalled in accordancewith the manufacturersinstructionsand local codes. Inthe absence of localcodes follow theNational Fuel GasCode, ANSI Z223.1.For indoor installation.PGB & PGJFor outdoor installationonly.WARNING: If not ins-talled, operated andmaintained in accordancewith the manufacturer'sinstructions,this product couldexpose you to subst-ances in fuel combuscancer,birth defectstion which can causedeath or serious illnessand which areknown to the State ofCalifornia to causeor other reproductiveharm.This product containsfiberglass insulation.Fiberglass insulationcontains a chemicalknown by the State ofCalifornia to causecancer.FOR YOUR SAFETYDo not store or use gasoline orother flammable vapors and liquids in the vicinity of thisor any other appliance.B14933-228IO-176 29