C11- MULTIFUNCTION CNC BOARD Rev. 9.3 - Stepper Motor ...

More documents

Recommendations

Info

C11 (Rev. 9.3) User ManualFig. 10 Wiring diagram to connect NPN proximity sensors with internal pull up resistor.Some NPN proximity sensor has a pull-up resistor (R1) internally. It is necessaryto know its value in order to connect safely the sensor with the BOB. Follow thisrecommendation:Connecting NPN open collector proximity sensor with the C11(R1+R2) Value (12V)Aprox. 10KΩ(R1+R2) Value (24V)Aprox. 25KΩRevision: 01/27/2010 http://cnc4pc.com/TechDocs/C11R9_3_User_Manual.pdf 10/22
C11 (Rev. 9.3) User ManualCalculating the R1 value.Note: Rx is the unknown resistor value.R X = V EX .(R/V) - R (1)Where:V EX is the external power supply voltageV is the voltage across the R resistorAn external resistor and a voltmeter are required to calculate the internal resistor (Rx)value.Note. The user should know the R value to do this operation. A 4.7KOhm @ 1/2W isrecommended.SAMPLE: if you are using a 12V power supply (V EX ), and using a 4.7KOhm asexternal resistor (R), then the voltage across R should be 6V, using the equation 1,the Rx value is 4.7KOhm.5.3 Connecting PNP sensors.Revision: 01/27/2010 http://cnc4pc.com/TechDocs/C11R9_3_User_Manual.pdf 11/22
Page 1: C11 (Rev. 9.3) User ManualC11- MULT
Page 4 and 5: C11 (Rev. 9.3) User Manual3. Specif
Page 6 and 7: C11 (Rev. 9.3) User ManualThe “In
Page 8 and 9: C11 (Rev. 9.3) User Manual5. Wiring
Page 12 and 13: C11 (Rev. 9.3) User ManualFig. 11 W
Page 14 and 15: C11 (Rev. 9.3) User Manual6. Specia
Page 16 and 17: C11 (Rev. 9.3) User ManualWiring:Be
Page 18 and 19: C11 (Rev. 9.3) User ManualFig. 12.
Page 20 and 21: C11 (Rev. 9.3) User ManualChanging
Page 22: C11 (Rev. 9.3) User ManualAll dimen

C11- MULTIFUNCTION CNC BOARD Rev. 9.3 - Stepper Motor ...

Create successful ePaper yourself

Delete template?

Save as template?