Seattle Diamond-Fyre - Avalon

All Avalon firestyles are proudly made in the U.S.A.Installation SpecificationsAlways refer to the and use the Installation Manual for complete install information.Minimum Framing Dimensions:Top VentRear VentIncluded Firestop (required) Part #250-00747Vent Clearances for 8”(203mm) dia. Vent: 1”(25mm) to the sides,1” (25mm) below, and4” (102mm) above thevent to combustibles.Route theelectrical line tothe position tothe left rear ofthe fireplace.33-1/2”851 mmMinimum enclosureheight = 38”Route theelectrical line tothe position tothe left rear ofthe fireplace.33-1/2”851 mm19-1/4”489 mm32-1/2”826 mm24-1/4”826 mm36-1/2””927 mm16-1/2”419 mm36-1/2”927 mm16-1/2”419 mmHearth Requirements:A non-combustible hearth extension is not required.However, if the heater is installed next to the floor, werecommend a hearth to protect the flooring surfacefrom discoloration.Listings:This appliance was listed by OMNI Test Labs to ANSIZ21.88 - report # 028-F-80c-5. The listing label is attachedto the appliance near the gas control valve.IAS (ICBO) ApprovalThis appliance was listed by OMNI Test Labs -IAS # TL130.Massachusetts ApprovalSubmitted to the Massachusetts Board of StateExaminers of Plumbers and Gas Fitters8” (203mm) Diameter Vent 4-3/4”121 mm30”762 mm34-1/4”794 mm16-1/4”413 mm32-1/2”826 mm18-4/4”476 mm36-1/4”921 mm33-1/4”845 mm30-1/4”768 mm28-3/4”730 mm1”25 mm8” (203mm) Diameter Vent24-1/4”616 mmWeight: 155 Lbs. (70.4 kg)Fi rest y l es for Lifewww.avalonfirestyle.comT MPhotos and illustrations are for descriptive purposes only. We reserve the right to improve or change our products without prior notification. Diamond-Fyre and allother trademarks belong to Travis Industries, inc. Consult the Owner’s Manual for complete installation requirements.© Copyright T. I. 2010 Printed in the U. S. A. 98800501