INSTALLATION MANUAL - Carefree of Colorado

More documents

Recommendations

Info

APEX Installation Manual Carefree of ColoradoWIRING DIAGRAM – 4 AWNINGS3 Conductor 14AWGNM Wire w/ Gnd333 Conductor 14AWGNM Wire w/ GndREDBLKWHTGRN1234567REDBLKWHTGRNAMDAUX SUNEYEDSKAwning #1SensorREDAwning #2BLKWHTGRNSensor5Ignition Switched+12VDC12VDCGroundSensor #1RemoteKey PadIgnitionLockoutSensor(Optional)Splitter4TOEYE PORTon RP24ProgramModePress to LearnTransmitterRFReceiverUPKey PadAMDSensor #2To 110VACBLKREDWHTGRN1234567AUX SUNEYEDSKWhtBlkGrn12345673 Conductor 14AWGNM Wire w/ Gnd333 Conductor 14AWGNM Wire w/ GndBLKREDWHTGRN1234567REDBLKWHTGRNDSK EYE AUX SUN AMDAwning #3SensorREDAwning #4BLKWHTGRNSensorSensor #32 Conductor 14AWGNM Wire w/ GndTo 110VACWhtBlkGrn1234567DETAIL A110VAC Power Line In(typical both boxes)GreenBlackRedTo 110VACREDBLKWHTGRN1234567DSK EYE AUX SUN AMDSensor #4GreenRedBlackYellowYellowCables are 4-wire RJ11terminated phone cord(straight, no twist).DR01514 052522-002r4
Carefree of Colorado Installation Manual APEXNOTES:1 Wire LegendRedBlackWhiteGreen (Ground)2345Awnings #1 & #4 shown as LH Motor, Awnings #2 & #3 shown as RH MotorFor LH Motor Configurations:Motor Red goes to Pin (1); Motor Black goes to Pin (2)For RH Motor Configurations:Motor Red goes to Pin (2); Motor Black goes to Pin (1)The SO cable from the 110VAC awning motor can only pass directly through a wall; it cannot be laid up in the walland must be connected to NM wire or individual wires in conduit no more than 6" past the point of entry.Splitter is used only when Optional Lock-Out Sensor is installed. Connect RF receiver directly to "EYE" ifLock-Out is not installed.Wires for Ignition Lock-Out Sensor are not pin specific.6 For screw type terminals: After testing connections, use Loctite 29005 or equivalentto secure screws in terminal block7 Cables are 4-wire RJ11 terminated phone cord (straight, no twist).8 Terminal block designations are for reference only. Actual boards may not be marked.Loctite29005Screw TypeTerminal BlockTO CONTROL BOARDFROM MOTOR #1 MOTOR #2 MOTOR #3 MOTOR #4AC Power Source White 4 4 4 4Black 5 5 5 5Ground 7 7 7 7Awning #1 Motor Black Refer to FlagRedNote 2White 3Ground 6Awning #2 Motor Black Refer to FlagRedNote 2White 3Ground 6Awning #3 Motor Black Refer to FlagRedNote 2White 3Ground 6Awning #4 Motor Black Refer to FlagRedNote 2White 3Ground 6#1 Sensor 10’ Cable “AMD”#2 Sensor 10’ Cable “AMD”#3 Sensor 10’ Cable “AMD”#4 Sensor 10’ Cable “AMD”Key Pad 25' Cable "DSK"Splitter 60" Cable "EYE"RF Receiver 60” Cable SplitterIgnition Lockout 60“ Cable SplitterNotes: 1. Splitter is used w/ Ignition Lock-Out only. If Lock-Out is not installed, connect the receiver directly to "EYE".2. Cable lengths are the lengths of the furnished cables. If a connection requires a length greater than thesupplied cable, the installer must provide a terminated jumper cable from the box location to the cable end.522522-002r4 15
Page 5: Carefree of Colorado Installation M
Page 8 and 9: APEX Installation Manual Carefree o
Page 20: APEX Installation Manual Carefree o

INSTALLATION MANUAL - Carefree of Colorado

Create successful ePaper yourself

Delete template?

Save as template?