RBK 825 Recumbent Bike - Experience™ Series - Precor

20 Operating and Maintaining the P20 ConsoleHour MeterEvent Description of EventNumber22 No motor pulses at start up23 Motor pulses missing after start up24 Reduce speed requested, speed is not reducing26 Motor pulse width incorrect27 Too much drive motor current28 Temperature too high29 Excessive AC input current30 Communications event lower board to upper board31 Incorrect Communications event upper board tolower board32 Communication event upper board to lower board33 Incorrect communications event lower board toupper board40 Lift motion detected42 Lift position value out of range43 Zero switch not found44 Un-commanded lift motion45 Lift going in the wrong direction50 Too much brake (magnet) current53 Cannot read target, cannot find home switch54 Target pulses lost during operation55 Brake home switch activated unexpectedly60 Auto Stop sensor failure (treadmill)61 Auto Stop not present (treadmill)Tracks the number of hours that a piece of equipment hasrun. The equipment also tracks elapsed minutes, but the valuethat displays is rounded up the nearest full hour.